Lighting Technologies NOTA LED 18 Montageanleitung Seite 6

2. Put mains cable through mounting pipe.
3. Provide power to luminaire by the means of sealed connector (should be ordered separately -
art. 4105001430), or any other sealed connector which can be tightened around cable outer
insulation and provide level of protection of at least IP67. For connector art. 4105001430
allowable outer diameter of cable is 7-12 mm. In case of using connectors which do not comply
with above mentioned requirements and absence of proper drainage the luminaire operation is
prohibited and warranty will be void.
4. Place the luminaire and lock it with 2 screws
5. Switch power on.
6. Connecting luminaries in a line
7. Bring mains/control cables using terminal blocks and junction box B (not included in
luminaire's
delivery set). Connection should be done according to polarity "L1" - phase conductor, "N" -
neutral conductor, - grounding (for versions with DMX protocol control wires should be
additionally connected according to polarity "+" and "-"). For versions of luminaries with 24VDC
power supply wires should be connected according to polarity: "+" - red or brown wire, "-" - blue or
black wire.
8. Seal cable entry in the junction box (with special flanges and silicone).
9. Connect the luminaire to the mains with leader cable and sealed connector (not included), or
sealed junction box, lock the joints.
10. Join the luminaries in a line with connectors, lock the joints, place plug at the end of a line, or
insulate the cable.
These instructions assume expert knowledge corresponding to a completed professional
education as an electrician.
Overall and installation dimensions, mm
1.
6