General Operation; Key Switch - Tarm Serie Bedienungsanleitung

Manual: tarm Series

8. General Operation

1. Power
Connect the power cord to the device and to the mains. Make sure that your device is pro-
vided with the correct voltage. Wrong voltage could lead to irreparable damages. Please
find the correct voltage data in the synoptical table at the end of this manual. Make sure
that the device is not directed to people or inflammable objects during installation. To
start the device, connect the interlock bridge and switch the device on. The "Emission
- Laser on" LED at the front side of the device begins to light up when the device is
ready for use.

2. Key Switch

There is a key switch at the back of the laser system. Please plug the key to the switch and
turn it on. The laser device only runs when the key is inserted and switched on. Prevent
misuse! Unplug the key when the laser is unattended to prevent misuse of the sys-
tem.
3. Safety Presets
This device has an integrated Scan Safety (SFS). If the Scan Safety is active (on), single
beams are prevented. If the Scan Safety is switched off, it is possible to create full power
single beams - be careful! On ShowNET devices, SFS can be activated / deactivated by
operating the push button on the back side of the device. On FB4 devices, SFS function is
accessible through FB4 menu.
Operating the laser system with disabled SFS may not be allowed in some countries.
Always ensure that maximum permissible exposure (MPE) is not exceeded in areas
accessible to the public or members of staff.
4. Modes / Functions
The different operation modes can be selected with using the rotaty knob at the back of
the device. Any change of the operation mode requires a restart of the device (dis-
connect power and reconnect it again). Do not change any setting during operation. Ran-
dom and dangerous laser output can occur!
5. Turn device off
To turn off the device, turn the key to ‚OFF' and disconnect the power cable from the
mains.
page 8 / 28