Items Included - Bosch GTA 60 W Professional Originalbetriebsanleitung

12 | English
Assembly

Items included

See the list of items included at the start of
the operating manual.
Check to ensure that all the parts listed below have been
supplied before assembling the saw stand:
No. Designation
(1) Mounting plate
(6) Upper frame with locking mechanism (2)
(7) Lower frame
(8) Wheel with linkage bar (9)
(10) Foot support
(11) Fastening set consisting of:
– Hexagon screws
M10 x 100
M10 x 50
M6 x 110
M6 x 75
M6 x 45
– Cross-head screws
M8 x 5
– Washers
M10
M10 (clamp disc)
M6
– Lock nuts
M10
M8
M6
Extra tools required (not included in the delivery):
– Cross-headed screwdriver
– Spanner (10 mm, 8 mm, 6 mm)
Assembling the Mobile Base Unit
– Carefully remove all parts included in the delivery from
their packaging.
– Remove all packing material.
– For assembly, follow figures A − E.
For figure A:
– Screw together the upper frame (6) and the lower
frame (7).
For figure B:
– Screw the left and right wheels (8) onto the upper
frame (6).
When doing so, ensure that the linkage bars (9) are facing
outwards and that the tyres of the wheels are facing towards
the lower frame (7).
1 609 92A 5YD | (20.10.2020)
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
For figure C:
– Screw together the foot support (10) and the two
wheels (8).
For figure D:
– Screw the mounting plate (1) on both sides to the upper
frame (6).
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
Quant-
For figure E:
ity
– Screw the left and right linkage bars (9) onto the mount-
1
ing plate (1).
1
Note: Do not over-tighten the nuts. The screwed-together
1
parts must be able to move freely.
2
Preparing the Saw Stand
1
Setting up the Saw Stand (see figure F)
Before securing the power tool, you must pull the base unit
apart.
6
– To release the lock bolts (4), gently pull the saw stand up-
2
wards by the handle (3).
4
4 – Open the locking mechanism (2). This retracts the lock
4 bolts which lock the wheels.
– Place one foot on the foot support (10) and push the
handle (3) downwards with both hands until the lock
6
bolts engage again.
– Close the locking mechanism (2).
18
2 The height-adjustable feet (5) will help you to straighten the
8 saw stand.
– Undo the wing nuts (12) and screw in/out the feet until
the saw stand is level.
6
6
Securing the Power Tool to the Mounting Plate
4
(see figure G)
The mounting plate (1) is suitable for general use. The vari-
ous different mounting holes allow both Bosch power tools
and competitor products to be mounted on the saw stand.
J
J
I
J
Bosch Power Tools