Herunterladen Inhalt Inhalt Diese Seite drucken

Der Move-Motor The Move Motor - Nonomo Move Montageanleitung

Federwiege mit move
Vorschau ausblenden Andere Handbücher für Move:
Inhaltsverzeichnis

Werbung

I
14

DER MOVE-MOTOR THE MOVE MOTOR

INBETRIEBNAHME SETUP
MIT NETZTEILSTECKER
Vor Inbetriebnahme mit dem Netzteil:
vergewissere dich, dass keine Batte-
rien in der Batteriebox sind.
Mit Schritt 4 fortfahren.
MIT BATTERIE
1
Die Stromversorgung erfolgt durch
sechs Batterien 1,5V LR6 (AA).
WICHTIG: Der Netzteilstecker muss für
den Gebrauch mit Batterien entfernt
werden.
1.
Schraube das Batteriefach auf
und hole die Batteriebox aus dem
3
NONOMO® Move
2. Lege die sechs neuen Batterien in
die Batteriebox und Schraube das
Batteriefach wieder zu.
3. Lege dein Kind in die NONOMO®.
4. Drehe den TIMER-Drehregler ein
wenig auf, bis das grüne LED-Licht
5
leuchtet.
5. Drehe den SPEED-Drehregler ein
wenig auf.
6. Bewege nun den Holzstab sanft
so lange auf und ab, bis das grü-
ne LED-Licht im Intervall leuchtet.
7.
Den TIMER sowie dem SPEED-
Drehregler kannst du nun
regulieren.
WITH POWER ADAPTER PLUG
Before starting up with the power adap-
ter, make sure that there are no batteries
in the battery box. Proceed to step 4.
WITH BATTERY
2
Power is supplied by six 1.5V LR6 (AA)
batteries. IMPORTANT: The power
adapter plug must be removed when
using the device with batteries.
1.
Unscrew the battery compartment
and take the battery box out of the
NONOMO® Move.
4
2. Place the six new batteries in the
battery box and screw the battery
compartment back down.
3. Put your child in the NONOMO®.
4. Turn the TIMER dial up a little until
the green LED light comes on.
5. Turn up the SPEED dial a little.
6
6. Now move the wooden stick gently
up and down until the green LED
light lights up at intervals.
7.
You can now regulate the TIMER
and the SPEED dial.
WICHTIG: Teste vor Erstinbetriebnahme den Aufbau und
die Funktionen des Motors mit einem Gewicht von 6 Kilo
(z.B. 4 x 1,5l-Flaschen), um sich an die Funktionsweise des
Motors zu gewöhnen und den Aufbau zu prüfen.
Der NONOMO® Move ist von uns so entwickelt worden,
dass er die normale Schwingbewegung unserer Federwie-
ge unterstützt.
BETRIEB OPERATION
TIMER: Motor und Zeitdauer einstellen. Der Federwiegen-
Motor kann bis zu 4 Stunden wiegen. Hierzu muss der
Timer ganz nach rechts gedreht werden.
SPEED: Reguliert die Geschwindigkeit. Je weiter man den
Geschwindigkeitsregler nach rechts dreht, desto höher
wird die Intensität. Bei jeder Inbetriebnahme des Motors
ist zunächst mit geringer Geschwindigkeit zu beginnen.
BETRIEB: Beide Drehregler müssen aufgedreht sein, damit
der Federwiegen-Motor wiegt. Die Federwiege ist am
Holzstab in Schwingung zu bringen. Hierzu die Wiegebe-
wegung mit dem Holzstab so lange durchführen, bis das
LED-Licht ca. 5 Sekunden im Intervall leuchtet. Die Inten-
sität des SPEED-Reglers ist abhängig von dem Gewicht
deines Kindes. Bitte beachte hierfür unsere Auflistung zu
Gewicht und Inbetriebnahme des Motors auf dieser Seite.
LED
LEUCHTET IS ON
Betriebsbereit / Beobachtung der Pendelschwingung
Ready for operation / Observation of the pendulum swing
Batterie leer / Fehler / Antrieb blockiert /
max. Schwingungsamplitude überschritten /
g-Kräfte überschritten
Battery empty / malfunction / drive blocked /
max. vibration amplitude exceeded /
g-forces exceeded
IMPORTANT: Before using for the first time, test the set-up
and the motor functions using a weight of 6 kilos (e.g., 4 x
1.5 L bottles) in order to get used to how the motor works
and to check the set-up.
We developed the NONOMO® Move in such a way that
it supports the normal swinging movement of our baby
hammock.
TIMER: Set motor and duration. The baby hammock
motor can rock for up to 4 hours. For this, the timer must
be turned all the way to the right.
SPEED: Regulates the speed. The further you turn the
speed control to the right, the higher the intensity. Every
time the motor is started up, it should initially be started
at a low speed.
OPERATION: Both control dials must be turned up for
the baby hammock to rock. The baby hammock should
be brought into a swinging movement on the wooden
stick. To do this, carry out the rocking movement with the
wooden stick until the LED light lights up at intervals of
approx. 5 seconds. The intensity of the SPEED controller
depends on the weight of your child. Please note our list
for weights and starting up the motor on this page.
BLINKT IS BLINKING
Betrieb
Operating
Batteriestand niedrig
Battery level low
I
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis