Environmental Protection - BGS technic 3286 Bedienungsanleitung

USE (2-2)
Place the cutting disc on the drive shaft and turn the screw and washer
clockwise direction. Make sure that the cutting disc bore is exactly mounted
on the drive shaft.
Re-install screw and washer at clockwise direction by one wrench while
holding the other wrench on the flats of the drive shaft. Make sure the screw
is securely tightened. Only use cutting disc that have an RPM rating equal
to or greater than the tool itself.
Remove the air cap from the tool air Inlet and connect the air supply hose to
the tool. Set the air pressure to 6.2 bar (90 psi).
Push forward the throttle lever lock and press down on the throttle lever.
How far the throttle lever is pressed determines the tool rotation speed.
Then the tool starts to work.

ENVIRONMENTAL PROTECTION

Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a
recycling centre and disposed of in a manner which is compatible
with the environment. Contact your local solid waste authority for recycling information
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed