Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The LED lightline has been tested for a maximum of 5 days in continuous underwater use. For
longer periods of underwater use we recommend our AQUALUC S:OLID underwater light line.
For more information, visit
www.barthelme.de
The product is suitable for installation on the floor, wall or ceiling - indoors and outdoors. Make
sure that the product is mounted on a clean, flat and stable surface.
Depending on the surface and the application, the installation can be performed with the
mounting profile (Art. 40100107 or 40100108), with thermal conductive double-sided adhesive
tape (Art. 30033009) or with construction adhesive (Art. 63500030).
The use of the mounting profile (Art. 40100107 or 40100108) is permitted only in combination
with the technical vaseline (Art. 63500022)! When inserting the AQUALUC mini the support
profile widens to a dimension of up to 16 mm.
When using the bracket set it is recommended to install a bracket approx. every 25 cm to
ensure a secure holding of the AQUALUC mini.
The AQUALUC mini must not be fitted over joints that may expand and contract due to ambient
conditions,. In particular, the thermal expsansion of materials must be taken into account. It
is therefore recommended to use mounting profi les according to the rule: AQUALUC length
in cm < mounting profile length in one piece. Failure to observe this rule will inevitably com-
press or stretch the LED light line and void the warranty.
If you use adhesive tape, please ensure that the surface to be taped is dry, even, and clean
(no fat, oil, silicone and dust particles). To achieve best adhesion, the surface of the AQUALUC
mini should also be clean (if necessary clean the surface of the LED light line with a soft,
slightly damp cloth. To remove more severe stains use a standard cleansing material without
abrasive elements).
Fix the tape on the bottom side of the AQUALUC mini or on the mounting surface and press
the LED light line firmly. The contact pressure should not exceed 10-15 N/cm
, otherwise the
2
LEDs or the electronic parts of the AQUALUC mini could be damaged.
If you select the construction adhesive then it is important to ensure an even and slight wave
form distribution. The amount of adhesive used should be relative to the size of the required
adhesive surface.
Werbung
