Assembly Of The Weighing Table; Inner Frame Assembly - KERN & SOHN TYPS-03A-B Installationsanleitung

3 Assembly of the weighing table

3.1 Inner frame assembly

1. Open the packing box, take out the top, middle, lower packing assemblies and the
accessory bags, See Figure 1.
2x granite
supporting rails
(long)
2x granite Accessory Bag
supporting rails
(short)
Lower packing
2. Remove the two granite supporting rails (long), the 2 granite supporting rails
(short) and the accessory bag from the lower packing layer.
3. Screw these parts together with the 4x M8x40 screws using the hexagon
wrench key from the bag in a way the resulting frame is plane and flat. (See
fig. 2)
4
1x inner side rail
(righthand)
Middle packing
Figure 1
Inner frame packing
Fig. 2
1x inner side
rail (lefthand) supporting rail
Top packing
YPS-03-IA-e-1910
1x granite
(below)