Rotating The Rotary Head (Image 3); Attaching/Detaching Blades; Edging; Trimming - Creative Concepts Freedom Razor Gebrauchsanweisung

Rotating the rotary head (image 3)

1. Hold the Freedom Razor TM
with the other hand gently press down the rotary knob
(image 1 part ).
2. Rotate the rotary head (image 1 part
the desired blade mount.
Do not turn the rotary head without pressing down the
rotary knob gently as it can damage the rotary head.
Image 3

Attaching/detaching blades

Be careful when attaching or detaching blades, blades
can be sharp.
compatible blades, refer to pages 10-11.
) clockwise to
Make sure to attach the blade of your choice to the
correct mount. See the table below and the List of
compatible blades, refer to pages 10-11.
1. To detach the blade after use, simply press the eject
button (image 1 part
the Freedom Razor
If the blade does not release keep pressing down on the
eject button, hold the blade from the sides and gently
pull out the blade from the mount.
Attach the blade of your choice to the Hydro/Quattro mount.
Attach the blade of your choice to the Fusion mount.
Attach the blade of your choice to the Unique mount.

Edging

Make sure not to apply to much pressure on the skin.
Injury or skin irritation may occur.
Make sure not to use the Freedom Razor
conjunction with deodorant or alcohol-based lotions
before or after use.
Make sure your skin is clean before use.
Make sure your skin and hair is dry before use.
The dual-sided trimming head can cut in both directions.
1.
trimmed.
2. Move the blade up or down while keeping the trimming

Trimming

1. Choose a trim height; 2, 4 or 6 mm.
2. Place the trimming comb attachment over the trimming
head. Press until the trimming comb clicks into place.
7
) located on the top back side of
.
TM
in
TM
List of