Media-Tech Smart Hands MT6214 Gebrauchsanleitung

Smart Hands Free Holder
Smartphone car holder with hands-free function
and FM transmitter
Introduction
Thank you for buying hands free set with FM transmit-
ter. Device is connected to SmartPhone headphone
socket (3.5mm jack). You can use car stereo system
instead SmartPhone built-in speaker. For private talks
you can use wireless earphone. Use USB socket to
charge your SmartPhone and other mobile devices.
Overview
ON/OFF switch
CH- Key
CH+ Key
Mini Wireless earphone
Installation
Put device into car lighter socket, next extend left
bracket and put SmartPhone into holder. Now plug
AUX cable into SmartPhone headphones socket.
Using the device
Use ON/OFF switch to power on the device. Adjust FM
frequency on the device, use CH-/CH+ buttons (short
press to change value by 0.1MHz, long press to speed
up adjusting). It is recommended not to use frequency
next to strong radio station. You can set frequency
within range 88.1–107.9MHz. You can save setting into
QuickStorage, press and hold QS button for 3 seconds.
Downloaded from www.Manualslib.com
AUX Cable
LED Display
Answer Key
QS Key
manuals search engine
To switch between saved settings press shortly QS but-
ton.
Now set exactly the same frequency in your car stereo
system. SmartPhone audio will be transmitted into
your car speakers.
Answer button*
In SmartPhone standby mode press once to start play-
ing MP3 fi les, press again to stop. When you have an
incoming call press once to accept, press again to end
call.
* Note! Answer key may not be supported by par-
ticular SmartPhones.
Earphone
When you take out earphone from the holder, sound
will be automatically transmitted only to earphone,
put it back to switch back to car speakers.
Note! Please charge earphone before use, leave it
for few hours when device is switched into ON posi-
tion.
Remote control
Frequency -
Number Key
You can use remote control to enter frequency directly.
Use number keys to enter value, press CH button to en-
ter value. Use CH-/CH+ buttons to adjust by 0.1MHz,
use QS button to switch between stored frequencies.
Note! Point remote control directly at IR receiver.
Specifi cation and appearance of product are subject to
change without prior notice. For technical support please
visit www.media-tech.eu.
MT6214
EN
User Manual
CH Set
Frequency +
Preset Frequency