Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MOUNTING INSTRUCTION
HOLESHOT DEVICE
Thank you for choosing XTRIG. All our products are designed and
manufactured to the highest standards using the best materials
available.
XTRIG products are race proven and ensure ultimate performance
XTRIG cannot be held responsible for incorrect assembly or
misuse of the product.
Please follow the assembly instructions. Expert advice and correct
installation of XTRIG products by an authorized XTRIG dealer are
essential to ensure optimum safety and functionality. Thank you
A
B
C
D
XTRIG_Holeshot_Mounting_Instructions.indd 1
MOUNTING OF CLAMP
Jack up motorcycle.
Place the clamping ring (1) on the fork
tube, push it all the way down and screw it
on with M3x12 bolt (3). The engagement
area must point to the front
MOUNTING THE RELEASE BUTTON ON
THE FORK GUARD
As an average measure down from the top
edge dimension "X" from table and drill a
hole with diameter 13.5 mm
- Position the release button in the hole from the outside and mark the four smaller holes with a
pencil (C).
- Drill out markings to Ø 5 mm.
- 5 mm holes on the rear side with 90° countersink until the bolt M5x8 (4) are flush with the
fork protection. (D)
- Screw the release button (2) onto the fork guard using the M5x8 bolt (4).
- Refit the fork guard.
- Loosen the clamping ring (1). Align the release button and the engagement area of the clamp.
Then apply Loctite 243 to the M3x12 bolt (3) and tighten the clamp to 1.2 Nm.
HANDLING
While sitting on the motorcycle, bend over the handlebars, grab the rim and
compress the fork, press the release button (2) and slowly extend until the
release button is fixed on the clamp. Then unleash the release button. When
the fork is compressed for the first time while driving, the release button is
automatically loosen from the clamp.
!
BEWARE
CHECK THE RELEASE BUTTON FOR EASE OF MOVEMENT BEFORE EACH
USE. AT TEMPERATURES BELOW 0° C THERE IS A RISK OF FREEZING.
.
SCOPE OF DELIVERY
(1) 1x clamping ring
(2) 1x release button
(3) 2x bolt M3x12
(4) 4x bolt M5x8
MODEL
MX / SX
Super Moto
DISTANCE „X"
110 ±10 mm
100 ±10 mm
05.05.21
Werbung
