Setting The Alarm - BEARWARE 304570 Bedienungsanleitung

5. Initial use
Take the product out of the package and remove all the packaging material. Open
the battery compartment at the back of the device and insert one 1.5 V AA battery.
Pay attention to the correct polarity of the contacts.
6. Setting the time
To set the time, turn the "Time Setting" potentiometer at the back of the device,
until the desired time is displayed on the alarm clock.
7. Alarm setting

7.1 Setting the alarm

To set the alarm, turn the "Alarm time setting" potentiometer at the back of
the device, until the desired alarm time is shown on the alarm clock. The alarm
indicator on the front shows the currently set alarm.
7.2 Enabling/disabling the alarm
To enable or disable the alarm, move the "Alarm ON / OFF" switch to ON
(switched on) or OFF (switched off) position.
7.3 Snoozing the alarm
Press the "Snooze/Light" button to snooze an alarm. The alarm is now turned off
for the snooze duration of about 5 minutes and then goes off again. This process
only works up to a maximum of 45 minutes.
8. Light
Press the "Snooze/Light" button to turn the back light on or off.
9. Safety instructions and disclaimer
Never try to open the device to repair or make modifications. Avoid contact with
the mains voltage. Do not short-circuit the product. The device is not waterproof,
hence please use it only in dry surroundings. Protect it from high humidity, water
and snow. Keep the device away from high temperatures. Do not expose the de-
10
English