Bluetooth ® Pairing - Hama TWS Sport Bedienungsanleitung

• Turn Off:
To switch off the earphones, simply place them back in the charging box.
Alternatively, you can switch the earphones on or off using the Multifunction
touch sensor (10). To do so, press and hold the Multifunction touch sensor (10)
for 5 seconds.
The first time the device is turned on, pairing is automatically started – see 5.1
Bluetooth
pairing.
®
5.1. Bluetooth
®
Note – Pairing
• Make sure that your Bluetooth
is activated.
• For more information, please refer to the operating instructions of your terminal
device.
• The earphones and the terminal device should be no further than 1 metre apart.
The smaller the distance, the better.
• Make sure that the earphones are switched off.
• Device off: To activate the earphones, remove them from the charging box at
the same time and place them back in the charging box. The status LEDs of the
earphones (7) are lit red. Remove the earphones once again. They now switch on
automatically, a voice says, 'Power on' and the status LEDs (7) flash blue. After
about 5 seconds, pairing begins and the two earphones connect to one another.
As soon as one of the two status LEDs (7) begins to emit flashes of alternating
red and blue light, your earphones are ready to be connected to your smartphone.
A voice says, 'Pairing'. The earphones are searching for a Bluetooth
• Open the Bluetooth
Sport appears in the list of Bluetooth
• Bluetooth
devices found.
®
• Select Hama TWS Sport and wait until the earphones are listed as connected in
the Bluetooth
®
Note – Bluetooth
If your terminal device requests a password to establish the connection, enter
0000.
pairing
-capable terminal device is on and Bluetooth
®
settings on your terminal device and wait until Hama TWS
®
settings on your terminal device. A voice says, 'Connected'.
password
®
devices found.
®
®
connection.
®
5