Samsung HT-D6750W Handbuch Seite 61

How to Link the Wireless Transmitter
with the Main Unit
1. Turn off your Home Cinema.
2. Press the 4, 7, 6, 3 buttons on the remote
control in order.
•
The Power LED blinks once.
3. Connect the iPod/iPhone to the Wireless
transmitter.
4. Turn on the iPod/iPhone. Press the "ID SET"
button on the back of the Wireless
transmitter for 5 seconds. The link light on
the wireless transmitter blinks rapidly.
5. Turn on your product.
•
To listen to music from iPod/iPhone over the
product, press the
"W. IPOD" mode.
•
After you select "W. IPOD" mode, turn the
volume of the product down to avoid hearing
damage.
•
You can control the speaker volume of iPod/
iPhone with a volume wheel or a volume bar.
•
When iPod/iPhone is stopped or in a power
saving mode, the Wireless transmitter enters
Sleep Mode.
When iPod/iPhone is set to Deep Sleep
Mode, the Wireless transmitter turns off.
HT-D6750W_ELS_1227.indd 61 HT-D6750W_ELS_1227.indd 61
Operation status of the wireless
transmitter's LED
button to select
Display
LINK
(Blue LED)
Pairing
LED ON successfully
completed
LED BLINK Processing iPod/
(Long blink) iPhone
LED BLINK Processing
(Short blink) pairing
!
CAUTION

If you use the main unit near a wireless device
such as a laptop computer, an AP, or Wifi , an
unstable operation error can occur.

Do not pair the SWA-5000 and iPod/iPhone at
the same time. If you pair them at the same
time, the iPod/iPhone and SWA-5000 may not
connect to the product.

The transmission distance from the product to
the wireless transmitter is about 5 meters, but
may vary depending on your operation
environment.

The audio signal may be weakened or even
lost where there is an obstacle such as a wall
or partition between the product and wireless
transmitter. You can also weaken or lose signal
if you move the wireless transmitter around.
Function
STANDBY
(Red LED)
STANDBY
LOW BATTERY
Pairing failed
61
English
2011-12-27 2011-12-27 9:26:16 9:26:16