Hama Scorpion Bedienungsanleitung Seite 6

00062408bda 21.04.2006
L L Scorpion with remote for high power amplifier
• Cool cylindrical shape
• 1.2 Farad max. 20V direct voltage
• Integrated multi-purpose display, rotatable 270°/80°
• 2 Status LEDs as charging/discharging function display
• Visual and audible reverse polarity display
• Integrated distributor blocks with transparent protective cover
• Includes special charging cable with integrated 100 Ohm resistor
• Includes 2 transparent plastic holders
• E approved
• High-quality select components
The Scorpion ensures:
• Increased amplifier power with effectively up to 35% more power
• Clear improvement in sound through less distortion
• More bass power. Without a capacitor, the on-board voltage drops 1 – 2 volts during sudden bursts of
bass. This results in distortion and loss of sound quality. The Power-Cap quickly compensates for this drop
in voltage and provides an audible solution.
• Anti-interference function for suppressing interference from the car electrical system
Functions:
• The charging/discharging function is indicated by the illuminated yellow LED
• The digital display shows the current on-board voltage. Display range approximately 9.5 to 19.5 V. Nothing
below this range is displayed. Above this range the display remains unchanged!
• Reverse polarity of the Scorpion is indicated by a loud audible signal and then by the illuminated red status
LED. Immediately disconnect the Scorpion from the car electrical system, as there is a risk of explosion or
irreparable damage!
• The rotatable display can be rotated by 270° or 80° to provide an optimal angle for reading. Do not adjust
the display outside of this range, since doing so will damage the internal string of cables!
Warning: The following must be observed!
• Disconnect the starter battery before beginning installation so that it is no longer connected to the car
electrical system
• The plus and minus poles of the Scorpion may not be reversed or short-circuited! Otherwise, there is a risk
of explosion or irreparable damage!
• During installation, ensure that no other parts of the vehicle are damaged or interfered with!
• Choose the installation location so that the Scorpion cannot interfere with moving parts or cause danger
when driving.
• Shorter cables routes to the amplifier optimise its effect. When using several amplifiers, mount the
Scorpion near the most powerful. Cable lengths less than 30cm to the amplifier are ideal.
• Cut the connection lines to length accordingly and equip them with terminals.
• The connection lines must have sufficient cross sections and must be fused in accordance with
regulations and laid correctly to prevent cables fires!
• The resistor in the charging cable can become excessively warm during operation – caution when
touching, there is a risk of getting burned!
• Buffer capacitors must be clamped or discharged when working on the vehicle's electronics and before
taking it to a repair shop.
• The capacitor must have a minimum capacity of 0.1 F per 100 watt of power.
• The capacitor cannot correct insufficient wiring or noise suppression of the vehicle.
7:31 Uhr Seite 7
5