Polti Vaporella AL Professional Bedienungsanleitung Seite 26

ENGLISH
IMPORTANT
• When the iron is no longer delivering steam, switch off the boiler
switch (11), open the patented safety cap (5), wait 2-3 minutes for
the boiler to cool down, and then refill it.
• During initial operation of the iron, a few drops of water mixed with
steam may come out of the soleplate since the temperature has not
yet perfectly stabilized. It is advisable not to direct the first jet onto
the fabric to be ironed.
• Make sure that the patented safety cap (5) is screwed down correc-
tly, otherwise steam leaks could occur.
WARNINGS
• Never leave the device unattended when it is plugged in.
• Always unplug before filling.
• The device is fitted with a safety temperature limiter, which should
only be replaced by an authorized engineer.
• When repairing or replacing any component, and in particular the
special safety cap, only use original
• If the patented safety cap cannot be opened for cold filling of the device,
plug in the power cable plug (4), switch on the iron switch (9) and press
the button (1) to eliminate any residual pressure in the boiler.
• If the power cable (4) needs to be replaced, ensure that the earth
wire is longer than the other wires.
parts.