Technical Data; Installation - Electrolux ERG47800 Benutzerinformation

Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
3. If necessary, replace the defective door
Height
Width
Depth
Height adjustment
The height of the appliance is adjustable
from 820 to 870 mm to fine up with existing
kitchen units.
Before installing the appliance between
units, adjust the height of the feet and rear
wheels. The wheels are factory set for a
height of 820 mm. To align the appliance to
a height of 870 mm, raise it by adjusting the
feet with a spanner, then remove the
wheels and refit them in the lowest position.
gaskets. Contact the Service Center.
1900 mm
860 mm
550 mm
14 h
230-240 V
50 Hz
electrolux 29