Bluetooth Operation - Trevi SB 8340 SW Gebrauchs- Und Anschlusshandbuch

ENGLISH
press the MUTE button (19) again.
Note:
- Some audio outputs which you connect the Sound Bar (like headphone output) can
control: make sure you
Bar will sound
EVEN
- If the sound played by the Sound Bar be distorted means that the input signal is too strong: lower the
of the Sound Bar or paid on a
- In case of connection to a TV by headphone output, it may happen that the sound reproduced by the Soundbar
is low at maximum
EVEN
an adapter (not supplied).
USB/SD CARD (TF CARD) INPUT
1. Insert a USB memory into the input (5) or an SD card into the input (6);
2. Turn ON the nit, it will automatically play the Music file inside the USB or SD Card;
3. Press(15) button on the remote control to momentarily stop playback. Press it again to resume playback;
4. Press  (16) or  (14) button on the remote control to select tracks.
AUX-IN
1. Plug in 3.5mm AUX cable;
2. Turn ON the unit, press (13) button on the remote control and select the AUX-IN input;
3. For proper playback sound refer to chapter VOLUME ADJUSTMENT AND MUTE FUNCTION.
OPTICAL INPUT
1. To use a digital optical cable (not included) to connect the OPTICAL input (8) to the digital optical output of your
TV or other source devices;
2. Turn ON the unit, press (13) button on remote control and select the OPTICAL input;
3. Adjust the volume using (18) Vol+ and (20) Vol- buttons.
Note:
- Some TVs or
DEVICES
- PCM digital audio must be set on the source

BLUETOOTH OPERATION

1. Turn on the unit; press (13) button on remote control to select the BLUETOOTH function;
2. The system automatically goes into search mode, if not press, for a few seconds, the UNPAIR button (21) on
remote control;
3. Activate the Bluetooth functionality on the external device to be paired;
4. Start the device search. At the end select the "SB 8340 SW" device;
5. Enter the password "0000" if required;
6. Press (15) button on remote control to start playback and the  (16) or  b14) button on remote control
to select tracks;
7. Press and hold for a few seconds UNPAIR (21) button on remote control to stop the active connection and pair
a new device.
EQUALIZER
The soundbar has a pre-set equalizer system, repeatedly press the EQ button (17) during playback to select the audio
dynamic that best suits the music style being played.
All manuals and user guides at all-guides.com
set on the source
HAVE
at maximum .
VOLUME
audio source
LEVEL
; in this case try connecting the Soundbar to the audio-scart output using
VOLUME
is necessary to enable the digital optical output.
an adequate
DEVICE LEVEL
output more low.
DEVICE
for playback from this input.
DEVICE
8
SB 8340 SW
its own
HAVE
audio output otherwise the Sound
VOLUME
VOLUME