DUOTECNO B.V.B.A.
Ten Briele 18.1 8200 Brugge
Tel: +32 (0)50 200 560
Fax: +32 (0)50 200 561
www.duotecno.be
DT40-BB
PIR 10 meter 110˚ horizontaal, 93˚ verticaal
SPECIFICATIES
OPTISCH
BEREIK:
10 meter
110° horizontaal, 93° verticaal
INBOUWHOOGTE:
tot 5 meter
ELECTRISCH
SPANNING:
12 VDC
EIGEN VERBRUIK:
11 mA @ 12VDC
UITGANG:
Solid-state relais (Potentiaal vrij contact), MAX 100mA @ 48V
FUNCTIE SCHAKELAAR
Bij het verzetten van de switch zal de led oplichten. Het aantal keer dat de led oplicht is gelijk aan de ingestelde stand.
Bv. 3x knipperen is stand 3 enz.
STAND
0 PIR is uitgeschakeld
1 NC contact (LED aan), bij detectie contact open ( LED uit)
2 NO contact ( LED uit), bij detectie contact gesloten ( LED aan)
3 NO contact, contact sluit bij detectie voor 2s, zolang er beweging is iedere 50s sluit het contact voor 2s
4 NC contact, contact opent bij detectie voor 2s, zolang er beweging is iedere 50s opent het contact voor 2s
5 NO contact, contact sluit bij detectie voor 300ms, zolang er beweging is iedere 50s sluit het contact voor 300ms
6 NC contact, contact opent bij detectie voor 300ms, zolang er beweging is iedere 50s opent het contact voor 300ms
LED
AAN
contact gesloten
UIT
contact open
AANSLUITINGEN
VOEDING
ROOD:
plus van 12 Volt DC voeding
ZWART:
min van 12 Volt DC voeding
CONTACT
WIT:
Potentiaal vrij contact --
Potentiaal vrij contact --
WIT:
GARANTIE
De garantie vervalt indien:
het apparaat niet correct werd geïnstalleerd en/of aangesloten.
-
Bij schade als gevolg van druk uitgeoefend op de sensor vervalt de garantie eveneens.
o
de schade of het defect het gevolg is van reparaties en/of wijzigingen in het apparaat welke zijn uitgevoerd door een niet door ons hiertoe gemachtigde
-
instantie of dealer.
het defect ontstaan is omdat er geen originele en/of compatibele accessoires werden op aangesloten.
-
het defect is veroorzaakt door vuur, bliksem, overstroming of elke andere natuurramp of ongeval.
-
het defect ontstaan is als gevolg van transport.
-
De garantie beperkt zich tot het vervangen van de door ons defect gevonden onderdelen.
De waarborg omvat geen vervoer- verzendingskosten noch reis- uurloonkosten.
DT40-BB
PIR 10 mètres 110˚ horizontal, 93˚ vertical
SPECIFICATIONS
OPTIQUE
PORTEE:
10 mètres
110° horizontal, 93° vertical
HAUTE D'INSTALLATION:
jusqu' à 5 mètres
ELECTRIQUE
TENSION:
12 VDC
CONSOMMATION PROPRE:
11 mA @ 12VDC
SORTIE:
Relais transistoré (contact exempt de potentiel), NC MAX 100mA @ 48V
SELECTEUR FONCTION
Par déplacer le sélecteur le LED va s'éclaircir. La quantité des signaux lumineux indique la fonction sélectée..
P.ex. 3x signaux lumineux indique la fonction 3, ...
FONCTION
0 PIR est en inactivité
1 NC contact (LED actif), contact ouvert en cas de détection (LED actif)
2 NO contact (LED inactif), contact fermé en cas de détection (LED inactif)
3 NO contact, contact fermé en cas de détection pour 2s, tant qu'il y a mouvement chaque 50s le contact ferme 2s
4 NC contact, contact ouvert en cas de détection pour 2s, tant qu'il y a mouvement chaque 50s le contact ouvre 2s
5 NO contact, contact fermé en cas de détection pour 300ms, tant qu'il y a mouvement chaque 50s le contact ferme 300ms
6 NC contact, contact ouvert en cas de détection pour 300ms, tant qu'il y a mouvement chaque 50s le contact ouvre 300ms
LED
ACTIF
contact fermé
INACTIF
contact ouvert
CONNEXIONS
ALIMENTATION
ROUGE:
pôle positif de l'alimentation 12VDC
NOIR:
pôle négatif de l'alimentation 12VDC
CONTACT
BLANC:
contact exempt de potentiel --
WIT:
contact exempt de potentiel --
GARANTIE
La garantie est déchue si :
l'appareil n'a pas été correctement installé et/ou connecté,
-
En cas de dommage dû à la pression sur le capteur, la garantie sera annulée
o
le dommage ou le défaut qui est la conséquence de réparations et/ou de modifications à l'appareil qui ont été exécutées par un organisme ou un
-
concessionnaire qui n'a pas été agréé par nos soins,
le défaut est survenu parce que des accessoires non d'origine et/ou non compatibles ont été raccordés,
-
le défaut a été occasionné par l'incendie, la foudre, l'inondation ou toute autre catastrophe naturelle ou accident,
-
le défaut est survenu à la suite du transport.
-
La garantie se limite au remplacement des éléments que nous avons jugés défectueux
La garantie ne comprend pas les frais de transport et d'envoi, ni les frais de main-d'œuvre et de déplacement.
|
|
INSTALLATIE
INSTALLATION