Werbung
Montageanleitung Schaukel „volucris2"
Artikel-Nr. 51 2024 401
Diagram 3: Top view „volucris2"
© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • Alle Rechte und Produktmodifikationen vorbehalten
7000
WERKSTOFF
DATUM:
11.04.2016
Behnke
GEZ:
Abmaße:
GEPR:
MAßSTAB:
Fertigung:
FREIG:
1x
OBERFLAECHEN NACH
ZUL. ABWEICHUNG
DIN ISO 1302 REIHE 2
DIN 2768 - mH
WERKSTUECKKANTEN
-0,3
Gewerbegebiet Larsheck
+0,3
56271 Kleinmaischeid
NACH DIN 6784
Deutschland
OHNE SCHRIFTLICHE ZUSTIMMUNG DER CONRADI + KAISER GMBH DARF DIESE TECHNISCHE UNTERLAGE WEDER VERVIELFÄLTIGT
NOCH DRITTEN MITGETEILT ODER ZUGÄNGLICH GEMACHT WERDEN NOCH IN SONSTIGER WEISE MISSBRÄEUCHLICH VERWENDET
WERDEN. ZUWIDERHANDLUNGEN WERDEN URHEBERRECHTLICH VERFOLGT.
5. After a setting period of 10-14 days, depending on weather conditions and
foundation size, clean the surface of the foundation, put the play equipment
on the foundation and screw it with the anchor bolts included in the delivery.
6. Seal the foundation with the safety cover required for the height of fall indica-
ted. Set up impact-absorbing playground surfacing according to EN 1177 HIC
1000.
Critical drop height: 1400 mm
Recommended surface material: sand,wood chips, gravel, synth. fall protec-
tion.
7. Screw the chains with the swing seats onto the swing suspension. Readjust
the screws on the swing bars.
8. Do not allow children to use the equipment before the installation has been
finished.
Attention: If the play equipment has been incompletely installed or partly dis-
mantled when carrying out maintenance and repair work, this may lead to par-
BENENNUNG:
NAME:
Draufsicht
ticular risks of injury for the user. For this reason, make clearly visible that the
ZG-NR:
equipment shall not be used in such cases.
0192-00-00
BESTELL-NR:
Projekt:
volucris2
NOTE: Play equipment, which contain components made of stainless steel
Gewicht:
132458.3
should not come with „normal" steel parts in contact. Those steel parts may rub
Rev.:
A3
off and leave small steel particles in combination with moisture brown rust stains.
If such corrosion occur on stainless steel parts, they are fine with an abrasive
(240 grit) to remove.
Please take care when transporting and setting up the fact that the components
are made of stainless steel with no „normal" steel parts in contact.
Stand: 19.04.2016 S. 3
Werbung
