Technical Data; English; Working Instructions - Milwaukee M18 BP Originalbetriebsanleitung

TECHNICAL DATA

Planer
Production code
No-load speed
Planing width
Planing depth
Rabbet depth
Battery voltage
Weight according EPTA-Procedure 01/2003 (Li-lon 4,0 Ah)
Noise information
Measured values determined according to EN 60 745. Typically, the A-weighted noise levels of the tool are:
Sound pressure level (Uncertainty K=3dB(A))
Sound power level (Uncertainty K=3dB(A))
Wear ear protectors!
Vibration information
Vibration total values (triaxial vector sum) determined according to EN 60745
GB
GB
Vibration emission value a
Uncertainty K =
WARNING
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745
and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications,
with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over
the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is
running but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories,
keep the hands warm, organisation of work patterns.
WARNING! Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
PLANER SAFETY WARNINGS
Wait for the cutter to stop before setting the tool down. An
exposed rotating cutter may engage the surface leading to possible
loss of control and serious injury.
Hold the power tool by insulated gripping surfaces only,
because the cutter may contact its own cord. Cutting a "live"
wire may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
Use clamps or another practical way to secure and support
the workpiece to a stable platform. Holding the work by your
hand or against the body leaves it unstable and may lead to loss of
control
ADDITIONAL SAFETY AND WORKING INSTRUCTIONS:
Wear ear protectors. Exposure to noise can cause hearing loss.
Always use the protective shields on the machine.
Use protective equipment. Always wear safety glasses when
working with the machine. The use of protective clothing is re-
commended, such as dust mask, protective gloves, sturdy non-slip

English

12
h
footwear, helmet and ear defenders.
The dust produced when using this tool may be harmful to health.
Do not inhale the dust. Use a dust absorption system and wear a
suitable dust protection mask. Remove deposited dust thoroughly,
e.g. with a vacuum cleaner.
Chips and splinters must not be removed while the machine is
running.
Do not drill the housing, as the protective insulation would be
rendered ineffective. Use adhesive labels.
Only plane with sharp blades and avoid metal (nails, screws).
Remove the battery pack before starting any work on the machine.

WORKING INSTRUCTIONS

Never reach into the danger area of the machine when it is running.
Place the front page of the machine on to the worpiece and switch
on, before the planer blade touches the workpiece and then guide
evenly over the workpiece.
The v-shape notch in the front of the supporting plate ensures safe
chamfering of edges.
M18 BP
4526 26 02...
... 000001-999999
14000 min
-1
82 mm
2,0 mm
10,7 mm
18 V
3,5 kg
82,8 dB (A)
93,8 dB (A)
4,3 m/s
2
1,5 m/s
2