Handle Installation; Reversing The Door - Respekta WKS 14 Bedienungsanleitung

All photos in this manual are for reference. The appliance you buy might not be exactly
the same as shown here.
Please refer to the actual product.
Installing handle and reversing the door
1. Parts for door reversing
①Door hinge cover ②Flange screw ③Door hinge ⑤Lower door hinge
④Cap
⑥Handle screw
⑦Handle

2. Handle installation

The handle is delivered in a separated package with screws
together inside the carton.
Reveal two small holes on the door frame from inner side by
①
pulling out a bit the door seal ② Aim the handle to the holes and
insert the screws from inside ③ Screw them up with screw-driver
Put back door seal to cover the screws.
④

3. Reversing the door

Our wine coolers are delivered with the door
opening from left to right. To reverse the
openingdirection:
1) Close the door.
2) Take off the door hinge cover
① on the up right corner; Unscrew the flange
screws②; Take off door hinge③; Remove the up
left side cap④.
3) Lift the door up until the door gets off the lower
door hinge⑤.
4) Unscrew the lower door hinge.
6