Cleaning And Maintenance - Ghibli & Wirbel T1 Gebrauch Und Wartung

For the 24 V device, PLEASE NOTE:
For a greater autonomy of the battery you
must stop the power supply during transfers.
Shutdown of the unit
- Press the switch (27 Fig.16) to turn off the
device (switch off the lamp, 230V model
only).
- Remove the plug (26 Fig.15) from the
outlet (230 V model only).
Charging the battery
If during use the devices switches off, it is
necessary to recharge the batteries, acting
as follows:
- Check if the switch (27 Fig.16) is on posi-
tion "0".
NOTE:
You cannot charge the batteries while the
device is on; there is a safety device which
stops automatically the machine if you con-
nect the charger to the battery.
NOTE:
You can charge the batteries even though
they aren't fully discharged without affecting
the battery life.
- It is possible to connect directly the cable
(13 Fig. 18) on the battery pack (14 Fig.
18) still mounted on the unit, or remove
the battery pack (14 Fig. 19) by moving
the safety lever (6 Fig.13), pressing the
release button (30 Fig. 19) and lifting the
battery pack (14 Fig. 19) and then re-
move it towards outside.
- Connect the charger as described in the
section "First battery charge".
- After charging the batteries, put them
back as described above.
NOTE:
Do not store the device after use, with the
battery discharged. If necessary, recharge
the battery.
For long storage periods of the device and
battery, periodically check the battery charge
status (15/30 days).
CLEANING AND
MAINTENANCE
DANGER:
Before performing any mainte-
nance work, remove the plug
from the wall outlet or battery
pack, depending on the model.
Removal and replacement dust col-
lector filter fleece
- Release the lever (1 Fig.1) and remove
the cover (2 Fig.2) completely, along with
the fleece filter bag (3 Fig.2).
- Remove the fleece filter bag (3 Fig.2) the
dust collector from the cover (2 Fig.2),
pick up the tab (31 Fig.20) and fold it into
the hole (32 Fig.20), fitting it on the rub-
ber edge, then throw it.
- Replace the fleece filter bag and reas-
semble in the reverse order of removal.
Control and cleaning of the cloth filter
- Release the lever (1 Fig.1) and remove
the cover (2 Fig.2) along with the paper
bag (3 Fig.2).
- Remove the cloth dust bag (4 Fig. 3) and
clean away the dust.
EN - 4
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968