Safety Instructions; Proper Use - Vollmer Heitronic 21218 Installations- Und Bedienungsanweisung

H. Vollmer GmbH
EN Installation and Operating Instructions
Connector
Art. No. 21218,21214
These operating instructions refer exclusively to these products.
They contain important information for the start-up and handling of the connectors.
Therefore pay attention to these operating instructions, even if you pass this product on to
third parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of
technology.
The connector fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions


The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!

We do not accept liability for any consequential damage!

Usage is strictly prohibited when the connector is damaged!

Do not allow children to play unsupervised in the vicinity of the connector or other electrical appliances.

Do not allow the connector to come into contact with extreme heat or naked flames.

The product in its entirety must not be altered or modified. Alterations to the connector invalidate the
guarantee.

The type plate must not be removed.

Do not connect the connector with other electrical loads.

3. Proper Use

The connector is designed to serve dry and secure interior areas.
This product must:

only be operated with a voltage of 12V

only be connected according to protection class III (three)

only be used on normal and/or non-flammable surfaces

not be exposed to heavy mechanical stress or extreme contamination
Installation Instructions Art. No: 21218,21214 Page 1 of 3
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach Stein
Dated: 13.10.2016