Westfalia WEH110 Originalanleitung Seite 10

 Do not grasp into the planning debris opening (3). Avoid contact with
rotating parts as well as with the planing blades.

Always switch on the machine before placing it against the workpiece.
Otherwise the machine could kick back.
 Make sure the planning sole lays flat against the workpiece, so the
machine cannot get snagged.
 Only operate the machine with all planing blades mounted.
 Do not operate the machine without the belt cover.

If pieces of wood or foreign objects become jammed in the machine, turn
off the electric planer and wait until the blade shaft (17) has come to
standstill. Then pull the plug and remove the wooden object.
 Always switch off the machine and pull the plug when taking a break,
when not in use or during maintenance.

Do not operate the machine with blunt or damaged blades. Blunt or
damaged blades may kick back and should be replaced immediately.
 Only use original replacement parts.

Always keep the machine clean, dry and free from oil or dirt.
 Periodically check all nuts, bolts and other fixings and tighten where
necessary.

Do not operate the machine if it does not work properly or is damaged.
Do not disassemble it and do not try to repair it yourself. In the case of
problems contact the customer support
10
department.