Werbung
EN
0 2
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective coun-
tries must be observed.
⁄ As a standard, the wash basin mixer taps are supplied
with a jet forming device equipped with a hand-
spray stream. For an alternative jet design, aerator
#98300000 is available as an option.
⁄ When operated in connection with a flow heater,
the fittings must always be opened fully. This ensures
proper function.
T E C H N I C A L D A T A
This mixer series-produced with EcoSmart
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
(flow limiter)
®
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 70°C
65°C
max. 70°C ⁄ 4 min
Do not use silicone containing acetic acid!
A D J U S T M E N T (see page 07)
To adjust the hot water limiter. Using a hot water
limiter in combination with a continuous flow
water heater is not recommended.
M A I N T E N A N C E (see page 9)
The check valves must be checked regularly
according to DIN EN 1717 in accordance with
national or regional regulations (at least once
a year).
D I M E N S I O N S (see page 08)
F L O W D I A G R A M (see page 08)
with EcoSmart
®
without EcoSmart
®
O P E R A T I O N (see page 10)
Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
A D J U S T A B L E S P O U T
For the version for right-handers, the spout re-
mains in the position as supplied to the customer.
For left-handers, the spout can be turned by 80°
to ensure perfect ergonomics. Simply unscrew
the jet forming device with a suitable wrench
and insert the spout in the different position.
Werbung
