Installation - Fulbat LiFePO4 Anleitung

voltage is less than 13.0 volts, additional charging is necessary.
If the battery becomes hot to the touch, stop charging. Allow battery to cool before
•
resuming.
Please check the battery voltage before installing; if the voltage is lower than 13V,
•
charge the battery see charging section
Make sure the charging system of your motorcycle is normal.
•
Remove the original battery from your motorcycle.
•
Compare the original battery with the new one; if
•
the new battery is smaller in any directions(len-
gth,width,height),use the self-adhesive foam to adjust
the battery size, so that the new battery fits the vehicle's
battery box (reference Figs).
In order to save the materials, please cut the self-ad-
•
hesive foam into small pieces, and then stick it to the
battery, that makes the battery achieve better heat
dissipation effect.
Connect correctly the positive and negative leads.
•
Verify that the correct size LifePO4 Lithium Iron battery has been chosen.
•
Do not engage your starter for longer than 5 seconds per try. Allow adequate time
•
between starting intervals (at least 5 seconds). Also make sure that your vehicle
is in a proper state of tune, as this will drastically shorten the starting time draw
on the battery.
Try to avoid keeping the vehicle light on for any extended period of time while the
•
engine is not running.This will help prevent over discharging.
If the vehicle is going to be stored for an extend period (more than 7 days), we suggest
•
removing the battery to lower the discharge rate. Vehicles installed with anti-theft
device will discharge the battery faster.
The performance of the battery may be influenced by the low temperature environ-
•
ment. For instance, When used under 0°C, it should be preheated for 1~2minutes
by turning on the headlamp, and then the vehicle can be started. In this way, a
better starting performance can be achieved and a longer battery service life
will be maintained.
FULBAT - www.fulbat.com

INSTALLATION

USAGE
3
Self-adhesive
Foam for sizing