Rebel RB-1060 Bedienungsanleitung Seite 33

10. Ensure that the switch is in the OFF position before inserting the battery. Inserting
the battery into power tools with the switch on invites trouble. Injury hazard.
11. Charge battery pack only at ambient temperatures between +10°C and +40°C. Store
the battery in a dry location protected from cold where temperature would not
exceed +40°C.
Charger use and care
1. Do not attempt to open or disassemble the charger. If the charger has been dropped
or is damaged in any way, stop using it and do not attempt to repair it. Return the
charger for repair to an authorized service center or a qualified person, to avoid any
danger to the user; or discard it according to local laws.
2. Protect the charger against any heat source (e.g. direct sunlight exposure, fire,
heater) to prevent any damage to the charger.
3. Do not expose the charger to water, moisture and cold. Risk of electric shock.
4. If the power cord or the plug becomes damaged, stop using the charger until it
has been repaired by a qualified person. If the supply cord is damaged, it must be
replaced by the manufacturer or its authorized service center, in order to avoid a
hazard. Risk of electric shock.
5. Only use the charger provided with the tool, or a same type or same model
charger to charge the battery. The use of other types of charger increases the risk of
electric shock, personal injury and damage.
6. Never attempt to recharge non-rechargeable batteries.
7. Only use the charger at ambient temperatures between +10°C and +40°C. Store charger
in a dry location protected from cold where temperature would not exceed +40°C.
8. The charger is intended for indoor use only. Place charger on solid, flat non-
flammable surface and away from any flammable materials when re-charging the
battery pack.
9. Do not recharge the battery pack in a wet or humid environment. The charger
and battery pack may heat during charging process.
Additional safety warnings for cordless air pumps
• Compressed air is not safe to be breathed in. Do not breath in air from the air pump or
from the connected object. Do not use the air pump as a breathing device.
• Keep monitoring the operation of the power tool. Exceeding the maximum pressure
may lead to damage or serious injury.
• Do not exceed the maximum pressure for the inflated object. Risk of bursting and
serious injury.Never direct a jet of compressed air toward people or animals. Risk of
serious injury.
• Do not use the air pump to spray chemicals. Your lungs can be damaged by inhaling
toxic fumes.
• Do not overload the power tool. Allow the air pump to cool for 5 minutes after each 5
minutes of continuous use.
• Make sure the hose if free from obstructions and snags. Entangled or snarled hoses
may cause loss of balance or footing and may become damaged.
• Do not carry the air pump by the hose or the adapter. Risk of power tool and/or
adapter damage.
33 EN