Operation - nemaxx KEN001COM Original-Gebrauchsanleitung

KEN001COM
Installation
After finding an appropriate location, the wall bracket
can be screwed onto the wall using the supplied
hardware.
Alternatively it can be stuck on using a pad sticker or
just rested on top of a unit.
To mount the bracket using hardware, use the
mounting plate as a guide to mark the two holes.
Drill these holes 6mm Ø, 30mm deep.
Insert the plugs into the hole and screw the bracket
on, ensuring the raised side is facing outward and is
pointing upward correctly as shown.
Push the back of the alarm against the bracket and slide down until it clicks to lock in
place. The battery compartment has latches that rise up to prevent the alarm being
installed without batteries, therefore please ensure the batteries are inserted before
installing the alarm.

Operation

The LCD screen and LEDs on the front of the alarm give vital information about the
working condition of the alarm and important ambient readings of the surroundings.
When the alarm is powered, the green power LED will flash once every 45 seconds to
indicate it is working. When the working voltage drops below 3.5V, the alarm will beep
when the power LED flashes. This indicates the battery power is insufficient; please
replace battery as soon as possible. On the LCD display, the battery status is also shown
constantly:
Indicates batteries are at full capacity and alarm is working with sufficient power.
Indicates batteries have sufficient capacity and alarm is working with sufficient power.
Indicates batteries capacity is getting low but alarm still has sufficient power.
Indicates batteries are critically low and alarm is working on the minimum required power
and requires replacement as soon as possible in order to keep the alarm functional.
EN
Wall bracket /
Back cover
Tapped screw hole
4
Version: 3.0
21.02.2017
Buckle to
hook on to
the back of
the alarm