Raco 11813 Bedienungsanleitung

LAMPESIMULATOR 11813
User guide
Dimensions LxBxH [mm] 190x110x42mm
LED Lights:
The lamp Simulator is designed for cars with Can-Bus that pull trailers with LED
lights. It should be mounted on the trailers and only trailers with LED lights.
Mounted on trailers with normal lamps, the vehicle will be overloaded/record errors.
Installation:
For exterior mounting, as the lamp simulator develops some heat, depending on the
load. Therefore, DO NOT mount it near temperature sensitive devices / components
and NOT near flammable materials.
Must be mounted on a heat conductive metal piece, with free air circulation as
possible. The surface must be as flat as possible, to avoid twist of the lamp simulator.
Must be fitted with 4 pieces. 5mm screws.
Termination:
The lamp simulator is equipped with a temperature fuse in the stop light. After
overload, it turns on again after approx. 30 min.
Usually the 1.5m long cable for connection to the car and the short 40cm cable for
internal connections on the trailer.
Lamp Simulator is designed to run with all known vehicles, but car manufacturers can produce functions that are
unknown to us, and therefore RACO do not guarantee these situations.
The pictures are illustrative and may vary from the originals.
Yellow = Left flash light
Blue = Rear fog light
Green = Right flash light
Brown = Right tail light
Red = Stop light
Black = Left tail light
Gray = Reversing light
White = Ground
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk
Lampesimulator
24 V & 15-pol
11813
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk