Kingfisher KI2300 Serie Kurzanleitung Seite 2

Quick Reference Guide – KI2300/KI2700 Series Loss Test Set
LIGHT SOURCE SECTION:
Manual operation
•
To remove interchangeable connector adaptor, press button
on front of case and pull off adaptor. This may be easier with
a test lead attached.
•
To turn on press [On/Off].
•
To view firmware version, hold [F4] then press [On/Off].
•
To view all display segments, press and hold [On/Off], [F1]
at the same time until it stops beeping.
•
To defeat auto power-off, hold [On/Off] for 3 seconds at turn
on until 'Perm' is displayed.
•
Low battery is indicated with a battery symbol.
•
To enter Source menu, press [Source].
•
To return to Home menu, press [Home].
•
To turn on back light press [ Backlight].
Source Menu:
•
Press [ - ] or [ + ] to select operating wavelength.
•
To change power level, press [F2] then use [ - ] or [ + ] (laser
light source only, not available for LED sources).
•
To restore default power level, press [F2] then press
[Toggle centre] (laser light source only, not available for LED
sources).
•
To select modulation while source is on, press and release
[Mode]. Press [Mode] again to select next available
frequency or ID-tone. Alternatively, press and hold [Mode]
then use [ - ] or [ + ] to cycle through all options.
•
To end modulation, press and hold [Mode] then press
[Toggle centre]. Alternatively, press and hold [Mode] for 3
sec.
Autotest Operation
•
To start Autotest press keys below on light source,
For light sources with up to 4 : Press [AUTOTEST].
For light source with 5 or more :
- press [Auto] to start Autotest for the default wavelength
group (possibly "singlemode").
- hold [-] then press [Auto] to initiate Autotest for the other
wavelength group (possibly "multimode")
•
To check wavelength status, e.g., if it is selected for limited
wavelength AutoTest, press [F4] while source is on.
•
To toggle selection of wavelengths for limited wavelength
AutoTest, press and hold [Toggle centre] then press [F4]
while source is on.
•
To start limited wavelength AutoTest, press and hold
[Toggle centre], then press [Auto].
English