Sentiotec LC-CC-VP Anleitung Seite 2

Manual for driver CC 24V 350mA (1-052-086 / LC-CC-VP)
Mechanical Structures and Dimension:
Technical data:
 Input voltage: 12-48VDC
 Output voltage: 4 x (3-46) VDC
 Output current: 4CH,350mA
 Output power: 4 x (1.05-16.1)W (350mA)
 Output type: Constant current
Match guide:
Use Controller's Match Key
1. Match: Short press match key, immediately press on/off key (at LR-1Z) or zone key 1-4 (at
LR-4Z) on the remote. The LED indicator fast flash a few times means match is successful.
2. Delete: Press and hold match key for 5s to delete all match, The LED indicator fast flash a few
times means all matched remotes were deleted.
Use Power Restart
1. Match: Switch off the power, then switch on power again, immediately short press on/off key
(at LR-1Z) or zone key 1-4 (at LR-4Z) 3 times on the remote. The light blinks 3 times means
match is successful.
2. Delete: Switch off the power, then switch on power again, immediately short press on/off key
(at LR-1Z) or zone key 1-4 (at LR-4Z) 5 times on the remote. The light blinks 5 times means all
matched remotes were deleted.
 Operation temperature: -30°C ~ +55°C
 Case temperature (Max.): +85°C
 IP rating: IP20
 Protection: Reverse Polarity / Short circuit
 Size: L x B x H: 175 x 45 x 27 mm
sentiotec GmbH | Division of Harvia Group | Wartenburger Straße 31, A-4840 Vöcklabruck I T +43 (0) 7672/22 900-50 | F -80
info@sentiotec.com | www.sentiotec.com
Feature:
Mini style controller with 4 channel constant current output.
•
Adopt 2.4GHz wireless technology, remote distance up to 30m.
•
One RF controller accept up to 10 remote control.
•
4096 levels 0-100% dimming smoothly without any flash.
•
Built in 10 dynamic mode, include jump or gradual change style.
•
Auto-transmitting function: Controller automatically transmit signal to another controller with 30m
•
control distance.
Synchronize on multiple number of controllers.
•
Connection guide:
Safety information:
1. The product shall be installed and serviced by a qualified person.
2. This product is non-waterproof (IP rating IP20)
3. Good heat dissipation will prolong the working life of the controller, please ensure good ventilation.
4. Please check if the output voltage of any power supplies used comply with the working voltage of
the products.
5. Ensure all wire connections and polarities are correct and secure before applying power to avoid
any damages to the LED lights.
6. If a fault occurs, please inform your supplier. Do not attempt to fix this product by yourself.