Linea 2000 DOMO DO158A Gebrauchsanleitung Seite 33

FILLING THE WATER RESERVOIR
Make sure the water reservoir contains water before activating the humidifier function.
1. Remove the water reservoir from the device. Fill the water reservoir with clean water. Make sure you
do not exceed the maximum level (see maximum indicator at the front of the device).
2. Place the 2 refrigerating elements with water in the freezer until completely frozen. Attention: never
open the refrigerating elements to prevent potential damage.
3. Place 1 refrigerating element inside the water reservoir. The water temperature will remain around
6°C lower than room temperature for around 4 hours, ensuring a chilled air flow. Attention: make
sure the maximum level of the water reservoir is not exceeded after adding the refrigerating
element.
4. Put the reservoir back in the device and close the clips.
Tip: add the second refrigerating element to lower the temperature even further. The 2 refrigerating
elements are reusable. Alternatively, add ice cubes instead of the refrigerating elements, they will have a
chilling effect as well.
ON/OFF BUTTON
Press this button to turn the device on or off. The latest configuration will be applied automatically when
the device is turned back on as long as you do not remove the power plug or turn off the switch. At the
standard setting, the device works as a ventilator in normal mode with low speed.
OSCILLATION BUTTON
Press the oscillation button to rotate the vertical air vent (behind the horizontal slats) left to right in
order to distribute the air. The associated symbol
deactivate the function.
You adjust the horizontal slats to change the direction of the airflow. Set the slats to the desired angle by
tilting these by hand.
www.domo-elektro.be
appears on the display. Press this button again to
33
DO158A