Crivit 339865 Bedienungs- Und Sicherheitshinweise

LED BIKE LIGHT SET
LED BIKE LIGHT SET LED-FAHRRADLEUCHTEN-SET
Operation and safety notes Bedienungs- und Sicherheitshinweise
IAN 339865_1910
Artikel-Nr. / Item No. 14168
List of pictograms used
USB – Universal Serial Bus –
Read the instructions! interface to port, e.g. on a
computer (charging only)
Danger to life and risk of German Federal Motor
accidents for infants and Transport Authority test symbol
K XXXXX
children! (K followed by approval number)
Dispose of the product and
Observe warnings and safety
packaging in an environmentally-
information!
friendly manner
Recycling code for the disposal
Caution! Danger of explosion!
21
of cardboard
PAP
Product meets the applicable
Symbol identifying electrical
European product-specific
and electronic devices
directives
Improper disposal of rechargeable
Recycling code for the disposal
batteries may result in
01
of polyester fibres and films
environmental damage! PET
Splash-proof, protection against
Headlight battery monitor
foreign bodies
DC
Direct current / voltage
LED Bike Light Set
1. Introduction
Congratulations on the purchase of your new product. You have chosen a
high-quality product. The instructions for use are a part of this product. It contains
important safety, assembly and disposal information. Before using the product,
please familiarise yourself with all safety notes and instructions for use. The product must
only be used as described and for the specified fields of application. When passing the
product on to others, be sure to also include all documentation.
1.1 Intended use
This product is suitable for lighting the roadway whilst cycling. The LED bike light set is approved
as exclusive lighting for all bicycles. Light distribution must not be impaired by other bicycle parts
or cargo. The product is intended for outdoor use. Any use not described above or product
modification is prohibited and can result in injuries and product damage. The manufacturer
assumes no liability for damage resulting from improper use. This product is not intended for
commercial use.
3.2 Installing the tail light (see Fig. B)
Secure the bracket in the desired location on the seat post or the rear seat stays
12
Ensure the are no objects blocking the tail light .
9
Apply tension to the rubber tab and hook in. To prevent damage, do not use tools
13
for this step.
Loosen the star screw on the bracket and adjust to the desired angle.
15 12
Then tighten the screw hand tight. To prevent damage, do not use tools for this step.
Slide the tail light into the bracket until you hear it lock into place. Be sure to
9 12
install the tail light as shown in Fig. B.
To remove the tail light , press the tail light lock
9 14
The tail lamp must be installed and adjusted so the reference axis is
ATTENTION!
parallel to the median longitudinal plane of the vehicle and parallel to the road.
4. Operation
4.1 Switching on / off
The headlight has three brightness settings.
1
On / Off switch
4
press once
Auto mode: The headlight is equipped with a sensor
1
automatically adjusts the brightness of the headlight
urroundings. When the sensor is active
control light flashes green.
3
press twice Power mode (60 Lux) for riding in unlit areas
press three times Standard mode (30 Lux) for riding in lit areas
press four times Eco mode (15 Lux) for riding in well-lit areas
press five times Power off
Battery status: Operating mode of the battery monitor
100 % - 75 % 4 green LEDs light up
75 % - 50 % 3 green LEDs light up
50 % - 25 % 2 green LEDs light up
25 % - 10 % 1 green LED lights up
10 % - 0 % 1 red LED flashes
When the battery monitor for the headlight comes on, it will continue to emit light for
2
at least 30 minutes.
A
1
1.2 Parts description
Headlight
1
Headlight battery monitor
2
Headlight sensor indicator light
3
Headlight on/off switch
4
Headlight sensor
5
Headlight bracket
6
Rubber tab for headlight bracket
7
Headlight lock
8
Tail light
9
1.3 Scope of delivery
1 Headlight
1 Tail light
1 Headlight bracket
1.4 Technical data
Headlight (auto-dimming)
Model designation:
Rated power:
IP rating:
Li-ion rechargeable
battery:
Charger output:
2. Safety notes
hazard posed by swallowing parts thereof. Children frequently underesti-
mate the dangers.
Always keep the product out of the reach of children. This product is not
a toy!
This product may be used by children aged 8 years and up, as well as by
persons with reduced physical, sensory or mental capacities or lacking ex-
perience and knowledge when supervised or instructed in safe product use
and they understand the associated risks. Do not allow children to play with
the product. Cleaning and user maintenance must not be performed by
children without supervision. Please note, damages caused by incorrect
GB/IE/NI
4.2 Tail light
.
13
On / Off switch
press once
press twice
When the battery monitor
least 30 minutes.
and take off the tail light .
9
4.3 Charging the headlight / tail light (see Fig. C + D)
Remove the rubber cover from the USB-C charging port
charging cable
Then connect the USB-C connector on the USB-C charging cable
laptop / standard USB charger with 5 V DC and 500-1000 mA. Using charging devi-
ces with different specifications can damage the batteries, and in turn the headlight
and tail light. This will void the warranty.
The headlight
monitor
2
recharged. The battery monitor
which are low and need to be recharged. The battery monitor lights up green whilst charg-
5
to the s
ing. When the batteries are ready for use, all 4 charging LEDs of the headlight bat-
1
(auto-mode), the sensor
5
tery monitor light up and the battery monitor on the tail light goes out. The headlight
and tail light
1
For the built-in batteries to operate at full power, be sure to charge the headlight
battery for at least 6 hours when charging for the first time (tail light battery: at least
5 hours). Please do not stop charging sooner, even if the LED is already extinguished.
After this, the recommended charging time for the headlight is approx. 3.5 hours
(recommended charging time for the tail light is 2.5 hours).
5. Cleaning and care
Never fully immerse the headlight and tail light in water. Do not use corrosive or
abrasive cleaning agents. These will damage the product.
Use a dry, lint-free cloth for cleaning and care.
6. Disposal
Observe the marking of the packaging materials for waste separation, which
are marked with abbreviations (a) and numbers (b) with following meaning:
b
a 1–7: plastics / 20–22: paper and fibreboard / 80–98: composite materials.
The product and packaging materials are recyclable, dispose of it separately for better
waste treatment.
GB/IE/NI
2
3
sensor
4
6
5
8
16
Tail light on / off switch
10
Tail light battery monitor
11
Tail light bracket
12
Rubber tab for tail light bracket
13
Tail light lock
14
Tail light bracket star screw
15
USB-C charging cable
16
USB-C charging port (headlight and
17
tail light)
1 Tail light bracket
1 USB-C charging cable
1 Instructions for assembly and use
Tail light
LI-3A-C/XC-266T Model designation: LR-2C-C/XC-249T
2 W Rated power: 0.2 W
IP44 per IP rating: IP44 per
DIN EN 60529 DIN EN 60529
Li-ion rechargeable
1300 mAh, 3.7 V battery: 300 mAh, 3.7 V
5 V DC max. Charger output: 5 V DC max.
1000 mA 1000 mA
DANGER TO LIFE AND RISK OF ACCI-
DENT FOR INFANTS AND CHILDREN! Never leave children
unsupervised with the packing material due to the suffocation
9
10
Power on
Power off
for the tail light comes on, it will continue to emit light for at
11
and connect the USB-C
17
to the USB charging port .
16 17
16
and tail light are equipped with a battery monitor. The battery
1 9
for the headlight flashes red when the batteries are low and need to be
for the tail light lights up blue when the batteries
11
are ready for use.
9
B
13
7
C
17 16
handling, non-compliance with the instructions for use or interference with
the device by unauthorised individuals are excluded from the warranty.
Never take the product apart. Improper repairs may result in considerable
danger to the user. Always have repairs performed by a professional. The
LED lights cannot be replaced.
DANGER TO LIFE AND RISK OF ACCIDENTS! Using
an incorrect charger can result in headlight
overheating and even explosion. This will void the warranty.
2.1 Rechargeable battery safety notes
CAUTION! DANGER OF EXPLOSION! Keep rechargeable
batteries away from children, do not throw rechargeable batteries
into fire, do not short-circuit and do not take apart.
Failure to observe this may discharge the rechargeable battery beyond
their end voltage. This poses a risk of leaking.
Avoid contact with the skin, eyes and mucous membranes if fluid has leaked
from the rechargeable batteries. In the event of contact with battery acid,
thoroughly flush the affected area with clean water and seek immediate
medical attention.
Note: If the red LED on the battery monitor
blue LED on the battery monitor
the batteries promptly.
3. Installation
3.1 Installing the headlight (see Fig. A)
Position the bracket in the desired location on the handlebar.
6
Secure the bracket to the handlebar using the rubber tab
6
ensure that there are no objects in front of the headlight
Apply tension to the rubber tab
for this step.
To adjust the optimum angle to the direction of travel, turn the headlight
correct position (see Fig. A).
Slide the headlight into the bracket
1
To remove, press the headlight lock
the bracket .
6
Routinely check the headlamp adjustment. The light cone must point
ATTENTION!
straight ahead, in the direction of travel, and must not be adjusted too high so as not
to blind oncoming traffic.
GB/IE/NI
Contact your local waste disposal authority for more details of how to dispose of your
worn-out product.
To help protect the environment, please dispose of the product properly when it
has reached the end of its useful life, not in the household waste. Please contact
your municipality for information on collection facilities and their opening hours.
Defective or used rechargeable batteries must be recycled according to Directive
2006/66/EC and its amendments. Return rechargeable batteries and / or the product
to the recycling facilities provided.
Improper disposal of rechargeable batteries may result in
environmental damage!
to a computer /
Rechargeable batteries may not be disposed with household waste. They may contain
toxic heavy metals and are subject to hazardous waste regulations. The chemical sym-
bols of the heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead. Therefore dis-
pose of used rechargeable batteries through a local collection point.
Improper disposal of rechargeable batteries destroys valuable resources and the hazardous
substances in the rechargeable batteries may pose a significant danger to human health
and environment. Separate collection/disposal of rechargeable batteries prevents dangers
to human health and environment, and valuable resources are regained by recycling.
7. Warranty
Dear customer,
The warranty for this product is 3 years from the date of purchase. In the event of product
defects, you have legal rights against the retailer of this product. Your legal rights are not
limited in any way by our warranty detailed below.
7.1 Warranty terms
The warranty period begins on the date of purchase. Please keep the original receipt in
a safe place. This document is required as your proof of purchase. Should this device show
any fault in materials or manufacture within three years from date of purchase, it will be
repaired or replaced - at our choice - by us free of charge. This warranty is conditional
on the defective product and the receipt of purchase being presented within the three year
warranty period, and on there being a brief written description of the nature of the defect
and of the date it arose. If the defect is covered by our warranty, we will return the repaired
device or replacement thereof. A repair or exchange of the device does not extend a
new warranty period. Repairs made under warranty do not extend the warranty period.
This also applies to replaced and repaired parts. Any damage or defects present at the
time of purchase must be reported immediately after unpacking the appliance. Repairs
made after the warranty period has expired are subject to payment.
GB/IE/NI
9
14
11
15 12 10
D
17 16
and tail light damage,
1 9
on the headlight or the
2 1
on the tail light lights up, recharge
11 9
. When doing so,
7
.
1
and hook in. To prevent damage, do not use tools
7
to the
1
until you hear it lock into place.
6
and slide the headlight forward out of
8 1
GB/IE/NI
GB/IE/NI