Before First Use - LIFESTYLER 350 007 Bedienungsanleitung


If the base or connector become wet, disconnect from the power supply and dry
the base and surface underneath with a dry cloth or tea towel before resuming
normal use.

Do not use outdoors.

This appliance is intended only for household use and is not suitable for any use
other than intended.

Repairs to this appliance should only be carried out by a qualified expert.

If the supply cord is damaged, it must be replaced by the manufacturer, its ser-
vice agent or similarly qualified persons in order to avoid a hazard.

Before First Use


Read all instructions carefully before use.

Before using your kettle ensure the voltage of your electricity supply is the same
as stated on the rating plate on your kettle.

Before normal use of your kettle, fill with water to the Max. mark on the water
gauge and boil. Leave to cool then rinse thoroughly with cold water to ensure the
kettle is completely clean.
Operation Guidelines

Remove your kettle from the base and open the Lid.

Fill with water to the desired level. N.B. Filling the kettle with too much or too
little water as represented by the Max. and Min. markings on the water level
gauge will result in poor operation, water leaking and spilling, or injury.

Make sure the base is on a firm, level surface before placing your kettle on it.
Then push the On/Off switch down to On position. The indicator light will illumi-
nate to show the kettle is switched on.

When the water has boiled, the kettle will automatically turn itself off.

Pour hot water carefully. Pouring too fast will result in splashing.

You can switch on the kettle again. After allowing the built-in thermal control
switch enough time to cool down (15~20 seconds).

Operation Guidlines
a) Switch on the Main Switch
b) Turn the Temperature Knob to "Boiling" zone.
c) Once the water boiled, kettle switch off automatically as normal electrical kettle.
d) No keep warm function for the "Boiling" zone. Boiled water will cool down.