Herunterladen Inhalt Inhalt Diese Seite drucken

MSW DENTPULLER.SET11 Bedienungsanleitung Seite 3

Inhaltsverzeichnis

Werbung

SICHERE ANWENDUNG DES GERÄTS
a)
Benutzen Sie das Gerät nicht, wenn der EIN-/AUS-
Schalter nicht ordnungsgemäß funktioniert. Geräte,
die nicht über den Schalter gesteuert werden können,
sind gefährlich und müssen repariert werden.
b)
Trennen Sie das Gerät vom Stromnetz, bevor Sie
Zubehör einstellen, auswechseln oder wenn Sie das
Gerät nicht mehr verwenden. Dies verringert das
Risiko einer versehentlichen Inbetriebnahme.
c)
Nicht
verwendete
Werkzeuge
sind
außerhalb
der Reichweite von Kindern sowie von Personen
aufzubewahren, welche weder das Gerät noch die
Anleitung kennen. In den Händen unerfahrener
Personen können diese Geräte eine Gefahr darstellen.
d)
Halten Sie das Gerät stets in einem einwandfreien
Zustand. Prüfen Sie vor jeder Inbetriebnahme, ob
am Gerät und seinen beweglichen Teilen Schäden
vorliegen (defekte Komponenten oder andere
Faktoren, die den sicheren Betrieb der Maschine
beeinträchtigen könnten). Im Falle eines Schadens
muss das Gerät vor Gebrauch in Reparatur gegeben
werden.
e)
Halten Sie das Gerät außerhalb der Reichweite von
Kindern.
f)
Reparatur und Wartung von Geräten dürfen
nur von qualifiziertem Fachpersonal und mit
Originalersatzteilen
durchgeführt
werden.
so wird die Sicherheit während der Nutzung
gewährleistet.
g)
Lassen Sie dieses Gerät während des Betriebs nicht
unbeaufsichtigt.
h)
Das Gerät muss regelmäßig gereinigt werden, damit
sich nicht dauerhaft Schmutz festsetzt.
i)
Das Gerät ist kein Spielzeug. Reinigung und Wartung
dürfen nicht von Kindern ohne Aufsicht durch eine
erwachsene Person durchgeführt werden..
j)
Es ist untersagt, in den Aufbau des Geräts
einzugreifen, um seine Parameter oder Konstruktion
zu ändern.
k)
Geräte von Feuer – und Wärmequellen fernhalten.
l)
Überlasten Sie das Gerät nicht.
m)
Achtung: Beim Betrieb der Pistole für Schmelzkleber
ist besondere Vorsicht geboten. Es besteht die
Gefahr von Verbrennungen.
ACHTUNG! Obwohl das Gerät mit dem Gedanken
an
die
Sicherheit
entworfen
wurde,
besitzt
es bestimmte Schutzmechanismen. Trotz der
Verwendung
zusätzlicher
Sicherheitselemente
besteht bei der Bedienung immer noch ein
Verletzungsrisiko. Es wird empfohlen, bei der
Nutzung Vorsicht und Vernunft walten zu lassen.
4
Nur
Rev. 19.06.2020
U S E R M A N U A L
LEGEND
The product satisfies the relevant safety
standards.
Read instructions before use.
The product must be recycled.
WARNING! or CAUTION! or REMEMBER!
Applicable to the given situation (general
warning sign).
ATTENTION! Electric shock warning!
Class II protection device with double insulation.
ATTENTION! Hot surface, risk of burns!
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury or even death.
The terms "device" or "product" are used in the warnings
and instructions to refer to DENTS REMOVAL TOOL KIT.
ELECTRICAL SAFETY
a)
The plug must fit the socket. Do not modify the
plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes,
heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device
is exposed to rain, comes into direct contact with a
wet surface or is operating in a damp environment.
Water getting into the device increases the risk of
damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it
to carry the device or to pull the plug out of a socket.
Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables
increase the risk of electric shock.
e)
If working with the device outdoors, make sure to
use an extension cord suitable for outdoor use.
Using an extension cord suitable for outdoor use
reduces the risk of electric shock.
f)
If using the device in a damp environment cannot
be avoided, a residual current device (RCD) should
be applied. The use of an RCD reduces the risk of
electric shock.
g)
Do not use the device if the power cord is damaged
or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or
the manufacturer's service centre.
h)
To avoid electric shock, do not immerse the cord,
plug or device in water or other liquids. Do not use
the device on wet surfaces.
i)
ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
j)
Do not use in very humid environments or in the
direct vicinity of water tanks.
k)
Prevent the device from getting wet. Risk of electric
shock!
Rev. 19.06.2020
SAFETY IN THE WORKPLACE
a)
Make sure the workplace is clean and well lit. A
messy or poorly lit workplace may lead to accidents.
Try to think ahead, observe what is going on and use
common sense when working with the device.
b)
Do not use the device in a potentially explosive
environment, for example in the presence of
flammable liquids, gases or dust.
c)
If you discover damage or irregular operation,
immediately switch the device off and report it to a
supervisor without delay.
d)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
e)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
f)
Children or unauthorised persons are forbidden to
enter a work station
g)
Please keep this manual available for future
reference. If this device is passed on to a third party,
the manual must be passed on with it.
h)
Keep packaging elements and small assembly parts
in a place not available to children.
i)
Keep the device away from children and animals.
j)
If this device is used together with another
equipment, the remaining instructions for use shall
also be followed.
PERSONAL SAFETY
a)
Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which
can significantly impair the ability to operate the
device.
b)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience
and/or knowledge unless they are supervised by
a person responsible for their safety or they have
received instruction on how to operate the device.
c)
When working with the device, use common sense
and stay alert. Temporary loss of concentration while
using the device may lead to serious injuries.
d)
To prevent the device from accidentally switching on,
make sure the switch is on the OFF position before
connecting to a power source.
e)
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
SAFE DEVICE USE
a)
Do not use the device if the ON/OFF switch does not
function properly (does not switch the device on and
off). Devices which cannot be switched on and off
using the ON/OFF switch are hazardous, should not
be operated and must be repaired.
b)
Make sure the plug is disconnected from the socket
before attempting any adjustments, accessory
replacements or before putting the device aside.
Such precautions will reduce the risk of accidentally
activating the device.
c)
When not in use, store in a safe place, away from
children and people not familiar with the device who
have not read the user manual. The device may pose
a hazard in the hands of inexperienced users.
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Dentpuller.set16

Inhaltsverzeichnis