Wörlein SOUNDMASTER SCD7900WE Bedienungsanleitung Seite 22

DAB SCANNING
RE-SCANNING
STATIONS
When first used, your radio scanned the DAB band for available stations. The station services
found were then stored in your system's memory.
You can re -scan the band at any time if you move to a different area or just to refresh the stored
list of available stations.
To scan for DAB stations manually:
· Set the function selector to TUNER, then press MODE button to select DAB mode.
· Press the SCAN button on the front panel.
The scanning process will take a few minutes. The number of services found during the scan
will be shown at the right side of the display.
After the scan, the radio will re -tune to the first station in the station list to play if it is available. To
select this station, you can continue to browse for another station as described on the
previous page.
FULL SCAN: Press SCAN button to enable Auto scan
MANUAL TUNING: Press and Hold the TUNING knob in few second until display show "Manual
tuning". Right now enables you to search the band manually, stepping through the ensemble
numbers to check if any have usable signal strength.
Manual tuning is not necessary in normal operation where scanning will have automatically
established a station list of all useable stations.
DAB DISPLAY MODES
DISPLAY MODE OPTIONS
The bottom line of the display can be switched to show different items of information that may be
transmitted with a DAB station.
Choosing the information display:
Press the INFO button on the front panel repeatedly to change the information displayed while
playing a DAB radio station.
The full range of display options are shown below. Some stations may not broadcast all of
these options.
DLS Scrolling Text > Program Type > Ensemble name> Ensemble Frequency
Rate> Signal Strength > Time/ Date
FOR DAB
> Audio Bit