Fields Of Application - clearaudio electronic Accurate Power Generator Bedienungsanleitung

When the set-up is finished, switch mains to "ON" position on rear panel and next switch on the front
panel the switch to "ON". The blue LED should come on.
The right switch on the front panel changes operating frequencies between channel 1 (50 or 60 Hz)
and channel 2 (any higher frequency below 92 Hz).
If you are using your clearaudio
with three motors), the factory settings need not be adjusted. LEDs will indicate the speed selected,
either 33 1/3 rpm (50 Hz) or 45 rpm (67.5 Hz respectively 81 Hz).
- Frequency and speed tuning -
The clearaudio
calibrating screws located on the front panel.
The left calibration screw marked "cal" adjusts channel 1, while the right calibration screw marked by
"cal" adjusts channel 2. Check the speed with a strobe light and disc.
- Fields of application –
The clearaudio APG is able to run with following equipment:
- Turntable
- Phono-preamplifier
- Preamplifier
- Laser-Turntable
- Tuner
- CD-Player and – converter
- Microphone preamplifier
- Mixer
- Tape recorder
- CDR unit
- Switch – off -
If the
also on the main on / off switch on the rear of the
APG front
We wish you a lot of enjoyment with your
Page / Seite 3
Downloaded from www.Manualslib.com
APG
allows you to set and maintain an exact frequency / speed by slowly turning the
APG
is not in use, always switch the
:
manuals search engine
Accurate Power Generator
APG
with a clearaudio turntable (such as the
APG
off using the off / on switch not only at the front, but
APG
.
APG rear
Accurate Power Generator
User Manual / Bedienungsanleitung
Master Reference
:
!
 clearaudio electronic GmbH 2012