Omnitronic 200010995 Bedienungsanleitung

USER'S MANUAL
AUDIO TECHNIQUE
Stereo Program Selector
The program selector was designed for use in audio systems. It switches one of three stereo signal
sources to two stereo speaker outputs. The program selector must be installed into a customary flush
socket or into an optional surface socket.
Switches one of 3 stereo signal sources to 2 stereo speaker outputs
Suitable for hifi applications
Screw plug connection
Flush mounting in customary 60 mm wall sockets
Surface mounting with optional PA SF housing
Plastic front panel and knob available in
Safety Instructions
Before your initial start-up, please make sure that there are no transport damages. Should there be
any, do not take the device into operation and immediately consult your dealer.
Operate the device only after having familiarized with its functions. Do not permit operation by
persons not qualified for operating the device.
This product was designed for indoor use only. Protect the device against humidity and heat. The
ambient temperature must always be between 0° C and 40° C. Keep away from heaters and other
heating sources!
Speaker cables are sensitive to electrical interference. Hence, it is recommended to lay them at a
distance of several meters to sources of interference (e.g. dimmers, light switches).
Maintenance and service operations are only to be carried out by authorized dealers. Damage,
caused by manual modifications on the device are not subject to warranty. If the device is used for
other purposes than originally intended or if it is not correctly connected, the product may suffer
damages and the guarantee becomes void.
For cleaning, please use a soft lint-free and moistened cloth. Never use alcohol or solvents!
© Copyright
Nachdruck verboten!
Reproduction prohibited!
for 3 signal sources
white, black and silver
Stereo Program Selector
Electrical Connection
Installation should only be carried out by skilled personnel!
connecting.
Signal source 1 (left) +
Signal source 2 (left) +
Signal source 3 (left) +
Signal source 1 (left) -
Signal source 2 (left) -
Signal source 3 (left) -
Speaker (left)
If the audio system is turned on, turn it off before making any connection.
To facilitate handling, the terminals can be removed from their plug-in connections on the unit
and replaced after connection.
Connect the lines of the signal sources and the speakers to the positive and negative poles as
shown in the figure above.
Technical Specifications
Dimensions: .......................80 x 80 x 60 mm
Weight: ..............................190 g
Please note: Every information is subject to change without prior notice. 01.02.2008 ©
Turn off audio system before
+ Signal source 1 (right)
+ Signal source 2 (right)
+ Signal source 3 (right)
- Signal source 1 (right)
- Signal source 2 (right)
- Signal source 3 (right)
Speaker (right)
L+ L- R- R+
00033851.DOC, Version 1.0
www.omnitronic.com