Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3/ ELECTRICAL CONNECTIONS AND PRODUCT USAGE
Apogee® Drive connections
•
Power:
connect
the
connector to your power supply.
•
RPM sensor: connect the 3-pin single
wire connector to the motherboard CPU
fan header.
4/ SUPPLEMENTAL AMD® INSTALLATION GUIDE
a/ Apogee Drive conversion from Intel Socket 775 to AMD Universal housing
1.
Loosen and set aside all 6
screws as shown above.
5.
Remove o-rings from
socket 775 housing and..
b/ Installation on the motherboard
Socket AM2
Copyright Swiftech 2007 – All rights reserved – Last revision date: 8-31-07 - Information subject to change without notice – URL:
Rouchon Industries, Inc., dba Swiftech – 3400 Industry ave., suite 104, Lakewood, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
Critical recommendation:
Connecting the pump RPM sensor to the CPU fan header is critical in order to monitor the
4-pin
Molex
pump. All modern motherboards have safety features that you can enable in the BIOS that will
shut down the power in the event of a CPU fan failure or in this case in the event of a pump
malfunction. We cannot stress enough how important it is to enable this safety. While the
system will overheat if the radiator fan fails, it can still operate for a prolonged period of time
when the CPU is at idle, whereas a pump malfunction will result in a rapid (a few minutes) and
catastrophic system failure in all cases!
2.
Remove and set aside
copper base-plate.
6.
..install them to AMD
housing.
3.
Remove and set aside
base-plate o-ring.
7.
Place AMD housing onto
Apogee Drive body.
Socket 754/939/940, and F
4.
Remove socket 775
housing.
8.
Install base plate o-ring,
base plate, and fasten all 6
screws.
http://www.swiftech.com
help@swiftech.com
Page 2
Werbung
