Remington i-Light Pro IPL6500 Bedienungsanleitung Seite 17

ENGLISH
, The power switch is ON, but the unit is not working.
• Make sure the unit is plugged into a working electrical outlet.
• Try switching to a different outlet.
, The unit appears to have cracks or is broken.
• Do not use if the unit is damaged. If you have concerns about using the unit, discontinue use and
contact the Remington® Service Centre for further assistance.
, I have switched the unit ON, but I cannot increase or decrease the energy level.
• Try resetting the unit by turning it off and waiting several seconds before turning it back on.
, The Bulb Status Indicator Light turns green but the unit does not flash when the button is pressed.
• Make sure the Skin Contact Sensor is in full contact with the skin.
• Try resetting the unit by turning it off and waiting several seconds before turning it back on.
, There is a strange smell.
• Be sure the area is completely shaved before treatment.
, The treated areas become red after treatment.
• This is normal and the redness should subside. If not, try using a lower energy level.
, BE AWARE: If the unit is used over an extended period of time, the unit might automatically disable
momentarily (estimated 40 seconds) to cool down. Once the unit has cooled down, it will be ready to
use again.
All currently selected energy level
indicators flashing
All energy level indicators
flashing
LED's
All LED's flashing with warning
beep
Unit is overheated and is disabled
momentarily to cool down.
Unit is malfunctioning. Turn the
unit off, wait a few moments and
try again. If problem persists, the
unit should be returned for repair.
Treatment head is removed or
loose.
17