Stanley MOBILE Anleitung Seite 4

Downloaded from www.Manualslib.com
2.1 Battery/Charger
Connect with computer or charger through USB cable.
Note: charge time is about 2-3 hours. Red light is on
when charging and is off when fully charged.
2.2 Power on/off
2.2.1 Power on: Hold the MFK for 2 seconds, until you
see blue LED flashing, to power on the device. You will
then hear the tone to indicate "power on",
2.2.2 Power off: In standby or music play mode, hold
the Multi-function button for 3 seconds, you will see the
red light is on for 2 seconds. You will then hear the tone
to Indicate "power off".
2.3 Volume Adjust
2.3.1 Volume Up: Press Vol + repeatedly to Increase
the volume.
2.3.2 Volume Down: Press Vol - repeatedly to decrease
the volume.
2.4 Pairing and Connection
A. With the device switched off, press the MFK for
2 seconds until the red & blue LEDs flash alternately.
You will hear the tone to Indicate the device is enter
pairing mode.
B. Activate Bluetooth function of your mobile phone and
other device. C. Connect with your Bluetooth device(s)
1) Add or search device: when "SWS"appear, confirm
your selection. 2) Input password: 0000 if required.
2.5 Calling Operation
2.5.1 Calling: A. Answer the call: Short press the MFK
to answer an incoming call. B. Reject the call: Press
and hold the MFK for 2 seconds to reject the call. C. End
a call: After calling, short press the MFK to end the call
or end the call on the phone. D. Redial: Short press the
MFK twice to redial the last call. E. Microphone mute:
Short press Vol+ and Vol- once, to make themicrophone
mute. F. Before making a call please mate sure the
Microphone is not blocked.
2.5.2 Voice Dialing: (This function needs the support
of the mobile phone) In standby mode. Short press Vol+
& MFK once. You will hear the tone to indicate voice
dialling.
manuals search engine