Setting The Ring Tone - Me BELL-218 TX Anleitung

WIRELESS BELL BUTTON
MOD. BELL-218 TX
Please read the following instructions carefully and keep them for possible
later use!
No cables are necessary for this wireless bell button unit. If the bell button is
pressed a signal is sent to the bell unit, which activates the bell.
1 x 3 volt lithium battery ( CR2450 ) is already installed. Please remove the
battery contact strip if necessary. The bell button is ready for immediate use.
NOTE: You can use up to four transmitters per bell unit.
MOUNTING
To mount the unit please break out the two pre-drilled holes and use the
back as a template to mark the mounting position. Drill the holes and attach
the mounting plate to the wall with the screws and dowels ( included ) .
Replace the front section.

SETTING THE RING TONE

Ring tone selection is carried out using the small, black button ( 1 ) in the bell
13
BELL-218 TX
EN