Troubleshooting - Hoover IRONspeed Bedienungsanleitung

14 -
Ironspeeed_SR__1-15_union_pprod3.indd 14
Downloaded from www.Manualslib.com

Troubleshooting

Problem
The appliance does
not become hot
The appliance does
not produce steam
Steam escapes from
the calc removal cap
when ironing
The empty water tank
LED is on
The soleplates
becomes dirty or
brown
Water stripes appear
on the textile
Some scale deposit
appears on the
soleplate
GB
manuals search engine
Cause
There is a connection Check the mains cord, the
problem plug and the wall socket
The appliance is not Press on the on/off switch
switched on
The soleplate temperature Set a higher temperature of
is too low the soleplate
The appliance is not Press on the on/off switch
switched on
The boiler has not yet Wait a few moments until
heated up the steam ready LED is off
The water tank may be Refill the water tank
empty
You are not pressing the Press the steam trigger
steam trigger
The soleplate temperature It works but steam is not
is set to the maximum visible as very hot and dry
The calc removal valve is Switch off the appliance
not tightened enough and let it cool down.
Remove the calc removal
cap and tighten the valve
correctly
The anti-scale valve is Contact your after sales
damaged service
There is no more water in Refill the water tank with
the tank water
There should be chemical
or additives in the water additives in the water.
used for ironing
Contact your after sales
service if the linen is still
dirty
The linen is still dirty Clean the soleplate with a
non-metallic sponge
Your ironing board cover is Change the cover or use a
saturated in water mesh ironing board
Your boiler has not been Follow the indications in the
rinsed for a while appropriate chapter
Solution
1
11-12-2009 9:59:58