Rosewill RKM-1600RF Bedienungsanleitung Seite 7

Slim Wireless Multimedia Keyboard & Laser Mouse
ID Setting
In general, the mouse and keyboard kit were done the ID setting
while producing, User doesn't do any thing about the ID setting.
This ID-recognition function helps to protect against interference
from other RF keyboards and mouse in the same environment.
Remember to set the ID when you replace the batteries or your
keyboard or mouse do not work properly. Please follow below
steps to complete the necessary ID-Setting process for your
wireless mouse and USB nano receiver.
1. Make sure the keyboard and mouse hardware installation is completed.
2. Plug the USB nano receiver into your computer's USB port.
3. Waiting for the USB plug and play initialization completed, and the nano
receiver LED will light flush.
4. For the mouse ID setting: Keeping the mouse to close the receiver within 30cm,
press and hold both left and right button then turn on the power button on the
bottom of mouse at the same time, it will take about 3 to 4 seconds for linking.
For the keyboard ID setting：Keeping the keyboard to close the receiver within
30cm,press and hold the "Esc" key then removing and replacing the battery at
the same time it will take about 3 to 4 seconds for linking.
5. Once the ID setting process is completed, the receiver LED will light off.
The receiver LED will light on again when wireless keyboard and mouse
are working.
6. If the mouse or keyboard doesn't work properly, please remove the USB nano
receiver from computer's USB port, then repeat do step 3 to step 5 again.
Enjoy using your keyboard and mouse.
RKM-1600RF
1-5
User Manual