Konig Electronic HAV-IR20 Anleitung Seite 11

Table 2.4.3
2.4.4 Inputting Static IP
1. Then scroll up/down to [Network] and press ENTER/OK button.
2. Scroll up/down to [IP Setting] and then press ENTER/OK button to enter.
3. Select [IP Source] and press ENTER/OK button to switch [Dynamic] to [Static].
4. Scroll up/down to [TCP/IP] and press ENTER/OK button to start editing.
5. Press UP/DOWN to change characters and press LEFT/RIGHT button to shift.
6. After finishing, press REC button to confirm.
Downloaded from www.Manualslib.com
Network
Connect
Wizard
Manual Setup
Select [Connect] and switch [LAN] to
[WLAN].
Wizard
Apo1
D-LINK
Default
All available AP and its signal strength
will be shown on the screen.
Apply ?
SSID: Penbex-MIS
Key:0000000000
Confirm
manuals search engine
Network
LAN Connect
→
> Wizard
> Manual Setup
Select [Wizard] and press [ENTER/OK]
Passphease
65% > 0 0 0 0 0 0 0 0 0 0
→
71%
88% ENTER/OK: Next
Key in the encryption code and then
Network
Connect
→
Wizard
Manual Setup
will show up if connection is
11
WLAN
>
>
button
0
press [ENTER/OK]
LAN
>
>
successful