Technical Specifications; Led Display - Raikko PowerCase 4/4s i1400 Bedienungsanleitung

English

Technical Specifications

Name:
Battery type:
Capacity:
Input:
Output:
Standby period:
Talk time:
Internet usage:
Music playback:
Video playback:
Dimensions:
Weight:
Compatibility:
General Information:
Charging
(1) Use the supplied USB/microUSB cable to charge the PowerCase
via a PC or a USB network adapter.
(2) Should the iPhone™ be connected in conjunction with the
PowerCase to a power source, the battery of the iPhone™ will be
fully charged first. When complete, the battery of the PowerCase
is then charged.
12
Downloaded from www.Manualslib.com
PowerCase 4/4s i1400
PowerCase 4/4s i1400
Lithium-Polymer
1400 mAh
DC 5 V 500 mA
DC 5 V 500 mA
Up to 240 hours
Up to 5 hours
Up to 5 hours
Up to 8 hours with Wi-Fi
Up to 30 hours
Up to 8 hours
L 124 x W 61 x H 14 mm
54 g
iPhone™ 4/4S
manuals search engine
English
Energy procurement
Press and hold the power button down to switch the PowerCase on or
off. For as long as your iPhone™ and the PowerCase are connected to a
power source the energy demand of the iPhone™ is always provided for
first. Recharging of the internal battery commences after this.
Should there not be a connection to a power source, the energy required
to operate your iPhone™ is covered by the battery of the PowerCase
until the charge level drops below 5 %. Demands on the battery of the
iPhone™ are first made when the charge level of the PowerCase is
less than 5 %, a separation of the units is effected or the PowerCase is
switched off via the integrated switch.
In order to achieve maximum utilization of the additional energy in the
PowerCase, only switch this in if the internal battery of your iPhone™
must actually be recharged. The „holding" of a maximum charge state
costs, relatively, a lot of energy and it reduces the achievable extension
of the operating time significantly.

LED display

Press the button on the front of the device to check the charge
status of the PowerCase.
One LED glows:
Two LEDs glow:
Three LEDs glow:
Four LEDs glow:
During the charging process, progress is indicated in much the
same way, by a blinking of the LEDs. When all four LEDs glow
constantly the charging process of the battery is complete and it
is charged to 100 %. A full recharging cycle can take up to 4 hours
to complete.
PowerCase 4/4s i1400
< 25 %
25–50 %
50–75 %
75–100 %
13