Maintenance; Accessories - Sparky VC 1220 M Originalbetriebsanleitung

some air can also be drawn in along with the liquid.
The appliance is equipped with a float switch (5) (Fig. 18)
that will stop the vacuuming when the tank is full. You
will notice that suction has stopped by the motor now
running faster. In this event, switch the appliance off and
unplug it.
Be aware that the full tank can be very heavy.
Remove the cap from the drain outlet (21) and pour the
rest of the liquid into a suitable tank or drain. Then, you
can continue vacuuming after you have replaced the
drain outlet cap.
After wet vacuuming, switch off the appliance and un-
plug it. Empty the container and clean/dry it inside and
outside before putting it away.
IMPORTANT! After wet vacuuming, please proceed as
described in the section entitled „Dry Vacuum cleaning"
before you dry vacuum again.

ACCESSORIES

MODEL
Hose set
Two-part plastic tube
Chrome-plated
telescopic tube
Dust bag
Dry filter
Foam filter
PET pleated filter
Cellulose pleated
filter
Floor nozzle
Combo brush
Crevice nozzle
Air-control handle
Power tool adapter
Rollers
TROUBLE SHOOTING
Problem
The appliance doesn't work.
Dust is escaping from the motor
cover.
Low suction power and high motor
speed / vibrations
Original instructions
Downloaded from www.Manualslib.com
VC 1430MS
VC 1220M
•
•
•
•
•
•
•
•
2 castors + 2 castors +
2 big wheels 2 big wheel
Probable cause
No power
Functional fault in the power cord,
switch, or motor
Tank is full of liquid
The dust bag is missing or
damaged
Dust bag is full
manuals search engine
WARNING: Use only original SPARKY
accessories. The use of non original spare parts or
accessories presents potential danger and voids the
guarantee.
VI - Maintenance
▪ Make sure that the appliance is not plugged into the
power mains.
▪ Remove the suction hose (13) from the tank.
▪ Loosen the clamps (Fig.1) and separate the upper
section from the tank (Fig.2).
▪ Remove all the dirt and residue from the tank and the
hose.
▪ Clean the foam plastic filter (19) by washing it with a
mild detergent.
▪ Check the hoses and connections and check the
power cord for any damage.
•
▪ When the foam plastic filter (19) is removed, check the
float (5). To do this, take the upper section by the han-
dle and tip it carefully so that the filter basket is facing
•
upwards. The float should move freely up and down
(Fig.18).
•
WARNING: Never use alcohol, petrol or other
•
cleaning agent. Never use caustic agents to clean
•
plastic parts.
WARNING: Water must never come into
contact with the electric appliance.
•
•
IMPORTANT! To assure product safety and reliability,
•
repairs, maintenance and adjustment should be per-
•
formed by authorised SPARKY service centres or other
qualified service organisations, always using genuine
replacement parts.
Corrective action
Check the power supply
Test, repair or replace the
damaged part
Empty the tank
Put in a dust bag or replace it.
Replace the dust bag
7
EN