RIDGID V-1225 Bedienungsanleitung Seite 2

Operating Instructions
WARNING!
and the accompanying safety booklet
carefully before using this equipment. If
you are uncertain about any aspect of using this
tool, contact your RIDGID distributor for more
information.
Failure to understand and follow all instructions
may result in electric shock, fi re, and/or serious
personal injury.
SAVE THESE INSTRUCTIONS!
Safety instructions
WARNING! The vacuum cleaner is not suitable for removing health
hazardous dusts. Never vacuum fl ammable and explosive solvents,
objects soaked with solvents, explosive dusts and liquids such as petrol,
oil, alcohol and thinners, or substances that are hotter than 60°C as this
will result in an explosion or cause a fi re! The appliance must not be used
in the vicinity of fl ammable substances.
• The voltage on the appliance type plate must conform with the mains
voltage.
• The mains socket must be protected by a domestic fuse with the
appropriate amperage.
• The appliance and its accessories must not be operated if:
- damage (cracks/breakages) are visible on the appliance.
- the power cable is damaged or indicates signs of cracking or ageing.
- if invisible damage is suspected, for instance after dropping or fall-
ing.
• Never use damaged extension leads.
• Never draw the connecting cable over sharp edges, nor kink, fold or
squeeze.
• The socket on the appliance must only be used for the purpose
defi ned in these operating instructions.
• Do not allow electric rotating brushes to come into contact with the
power supply cable.
• Instantly switch off the appliance if foam or water leaks out. Empty the
container and folded fi lter.
• Acids, acetone and solvents can etch appliance parts. Do not leave
the appliance unattended. Always disconnect the plug from the mains
socket when work is interrupted for extended periods.
• Always switch off the appliance, and disconnect the plug from the
mains socket, after use and prior to any maintenance work.
• Never disconnect the appliance plug from the mains socket by pulling
the connecting cable.
• Repairs must only be completed by competent specialists or the after-
sales service. Only use original spare parts. An incorrectly repaired
appliance is a hazard for the user.
• Other work than the work described in these instructions must not be
performed.
• Liability for possible damage is not accepted if the appliance is
misused, incorrectly operated or not competently repaired.
Downloaded from www.Manualslib.com
GB
V1225, V1250
Read these instructions
manuals search engine
Prior to use
Please read these instructions carefully as they contain important
information concerning use, safety, maintenance and care. Keep these
operating instructions in a safe place and ensure that they are passed
on to any possible subsequent owner. Subject to changes of design and
confi guration without previous notifi cation.
Fields of application
For wet and dry vacuum cleaning. Not suitable for vacuuming health
hazardous dusts. The ON/OFF automatic switching system is intended for
the connection of electric tools.
Operation
When unpacking, check that the appliance is complete and that there is no
transport damage.
Electrical equipment
The appliance is switched ON/OFF with the switch 2a (see Fig. 1 on the top
section 1 of the appliance), or switch to automatic or vibration mode.
O = Suction OFF
I = Suction ON (manual operation)
A = Ready for ON/OFF automatic switching system (the vacuum cleaner
is switched on and off by the connected electric tool).
R = Filter cleaning function; in this setting the vibrator will operate for
7 seconds after which it will be automatically turned off.
AR = Appliance version featuring "AR" can be operated as described un-
der "A" except that automatic fi lter cleaning (as described under "R")
is turned on when the volume fl ow display lights up.
The power socket 2b is intended for the connection of an electric tool.
WARNING! An electric tool must be switched off when it is connected.
The socket is always live when the plug is inserted in a mains socket,
irrespective of the switch position. In the "0" switch setting, the socket can
be used for an extension line (e.g. for a light).
Connected load: Suction unit and appliance max. 16 A
Appliances with an electronic suction force control feature a rotary knob
2d with which the suction force can be adapted to the object that is being
cleaned. The vibrating device should be activated (switch position R) at the
latest when the volume fl ow display (2c) (warning light) lights up or when
the suction power decreases.
Vacuum cleaning
The suction force of appliances with a handle tube can be matched to the
object being cleaned with the secondary air slide.
Dry vacuum cleaning
Dry vacuum cleaning must only be performed with a dry fi lter, appliance and
accessories so that the dust cannot adhere and become encrusted. If the
appliance is used to vacuum soot, cement, gypsum, fl our and similar dusts,
it is advisable to use a paper fi lter bag.
A paper fi lter bag must always be used in conjunction with a fi lter
cartridge.
Wet vacuum cleaning
Vacuum cleaning is performed without a paper fi lter bag. The fi lter cassettes
are suitable for wet cleaning. The built-in sensor turns off the motor when
the container is full. Empty the container in the manner described below.
The restart lockout remains effective if the appliance is not switched off.
The appliance is only operational again after it has been switched off and
switched on again.
• Always lift the suction hose out of the liquid before emptying.
Ridge Tool Company
V1225, V1250
1