Technical Data - Audiotechnik Dietz ISO Bedienungsanleitung

8
Open wires
from the harness:

Technical data

Power supply:
Temperature range: - 40 - +85 °C
Weight:
Dimensions:
On demand please connect the followin
grey Speedsignal
blue: Signal for rear gear
For 66030, 66031_BP, 66032_BP:
The 4-pol plug from the harness is the connection for steering wheel control to the
radio. There are different cables available depending from the radio brand.
Connect the optional cable between this plug and the connection on the radio.
(Mostly 3.5 mm plug or single wire called „SWC" or „Remote Control")
For 66020, 66030, 66031_BP, 66032_BP:
Conncet the 14 pol-plug from the harness with the interface. In case of interface
66020 you have to open the interface box to find the connector.
Connect the double ISO connector with the opposite connector in the car.
If the LED from the interfac is not green after connecting to the car, it can be
necessary to change Can High and Can Low.
Therefore there are in the twisted white and green wires bullets.
If the CAN Bus wires are not connected in the ISO connector this must be done be
hand. The CAN Bus wires can be connected to the clima control unit. If the car was
delivered without OEM head unit it could be that the MERCEDES garage must be
code a head unit to the car, that the interface can work.
(colour of CAN Bus wire of the car are: brown/red CAN High and brown CAN Low.)
12 V DC
0,110 kg
Cable length approx. 300 mm
Audiotechnik Dietz
®
Copyright © by Audiotechnik Dietz
®
Vertriebs-GmbH
Maybachstr. 10
D-67269 Grünstadt
Germany
verkauf@dietz.biz
www.dietz.biz
Vertriebs-GmbH ● Germany
®
Rev 1, Stand: 02/2018