Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
1. Front safety guard
2. Fan blade nut
3. Fan blade
4. Threaded nut
5. Rear safety guard
6. Motor shaft
7. Motor housing
8. Oscillation button
1.
Insert the stay with the motor housing (7+9) into the foot (12).
2.
Fasten them from below using the supplied screws (13) and a screwdriver.
3.
Install the supplied plastic pad (16) to the bottom.
4.
Remove the fan blade screw (2) and the threaded nut (4) from the motor shaft and put
them aside.
5.
Now place the rear safety guard (5) on the motor shaft (6) and make sure the opening
for the fastening screw (10) points down.
6.
Put the threaded nut (4) back on to secure the rear safety guard (5).
7.
After that slide the fan blade (3) onto the motor shaft (6) in such a way that it locks into
the designated notch.
8.
Screw the fan blade screw (2) onto the motor shaft (6) to secure the fan blades (3).
9.
Install the vane(14) on the front safety guard (1) with the supplied vane screws (15).
10.
Put the front safety guard (1) on the rear safety guard (4) by placing the upper hook of
the front safety guard onto the rear safety guard. Make sure the opening for the
fastening screw (10) points down and that it is flush with the opening on the rear safety
guard.
11.
Now fasten the two safety guards by closing all clamps followed by tightening the
fastening screw (10).
PART DESIGNATIONS
5
3
4
2
1
11
12
13
9. Stay
10. Fastening screw
11. Operating panel
12. Foot
13. Screws
14. Vane
15. Vane screws 3x
16. Plastic pad
ASSEMBLY INSTRUCTIONS
Seite 10 von 13
6
7 8
Werbung
Inhaltsverzeichnis
